Cisco 350-080 Online Practice Questions and Exam Preparation

Cisco 350-080 Online Questions & Answers

• Question 461:

  Which option lists the valid roles for VSM?

  A. primary and secondary
  B. standalone, primary, and secondary
  C. central, primary, and secondary
  D. master and slave
  B. standalone, primary, and secondary

• Question 462:

  Refer to the exhibit.

  

  Which statement is not true?

  A. Network to server unicast traffic is forwarded to the server only if it arrives on the pinned uplink port.
  B. Unknown unicast messages that are received on the uplink interface frame are dropped.
  C. Unknown unicast messages that are received on the server interface frame are flooded to all the up-links and servers ports in the fabric interconnect where the packets are received.
  D. Broadcast messages that are received on server interface are flooded to server links and pinned port.
  C. Unknown unicast messages that are received on the server interface frame are flooded to all the up-links and servers ports in the fabric interconnect where the packets are received.

• Question 463:

  Drag Drop

  Select and Place:

  

  

• Question 464:

  Which statement best describes ACL configuration using configuration session mode on Cisco Nexus switches?

  A. The verify command will validate commands entered for syntax errors.
  B. The save command will save the commands entered to the startup configuration.
  C. The network administrator can perform a dry-run ACL configuration by verifying the configuration against the hardware and software resources available before applying it.
  D. Configuration sessions can be saved and resumed at any time, even after upgrading NX-OS Software on the switch with ISSU.
  E. Configuration sessions are global for all VDCs on the Nexus 7000.
  C. The network administrator can perform a dry-run ACL configuration by verifying the configuration against the hardware and software resources available before applying it.

• Question 465:

  Which two statements about enhanced zoning are true? (Choose two.)

  A. Enhanced zoning is a mode that shows much more detail for the SAN choices when it is viewed in Fabric Manager.
  B. Enhanced zoning cannot be enabled per VSAN. It is a chassis-wide setting.
  C. Enhanced zoning sets the default zone to the same state in all switches.
  D. Enhanced zoning cannot be enabled in an FCoE environment.
  E. Enhanced zoning sends ACA to lock the fabric when the administrator starts a zone change.
  C. Enhanced zoning sets the default zone to the same state in all switches.
  E. Enhanced zoning sends ACA to lock the fabric when the administrator starts a zone change.

• Question 466:

  Which of these commands will allow you to set end-host mode for SAN connectivity?

  A. UCS-A # scope fc-uplink UCS-A /fc-uplink # set mode end-host UCS-A /fc-uplink* # commit-buffer
  B. UCS-A# scope eth-uplink UCS-A /eth-uplink # set mode end-host WarninG. When committed, this change will cause the switch to reboot UCS-A /eth-uplink* # commit-buffer
  C. UCS-A# scope fabric-interconnect a UCS-A /fabric-interconnect # set mode end-host UCS-A /fabric-interconnect* # commit-buffer
  D. UCS-A# scope system UCS-A /system* # set mode end-host UCS-A /system* # commit-buffer
  A. UCS-A # scope fc-uplink UCS-A /fc-uplink # set mode end-host UCS-A /fc-uplink* # commit-buffer

• Question 467:

  Refer to the exhibit.

  

  Which two statements about the HSRPV6 implementation for company ABC are true? (Choose two)

  A. HSRP version #1 or #2 is supported.
  B. The UDP port is port 2029.
  C. The virtual MAC address range is 0005.73A0.0FFF.
  D. The hop limit is set to 127.
  E. The multicast link-local IP destination address is FF08::66.
  B. The UDP port is port 2029.
  C. The virtual MAC address range is 0005.73A0.0FFF.

• Question 468:

  Application Control Engine (ACE) can check the health of servers and server farms by configuring health probes (which are sometimes referred to as keepalives). A probe can be one of many types. Which are valid ACE probes? (Choose three.)

  A. HTTP
  B. Java scripting
  C. TCL scripting
  D. RADIUS
  E. TACACS
  A. HTTP
  C. TCL scripting
  D. RADIUS

• Question 469:

  Drag Drop

  Select and Place:

  

  

• Question 470:

  Where can port profiles be applied to a virtual machine?

  A. on the VSM only
  B. on vCenter only
  C. on VSM and vCenter
  D. on VSM and VEM
  E. on VSM, VEM, and vCenter
  B. on vCenter only