Cisco 350-080 Online Practice Questions and Exam Preparation

Cisco 350-080 Online Questions & Answers

• Question 11:

  ON NO:70

  Which option lists the main components of the Cisco Nexus 1000V Series Switch?

  A. the virtual supervisory module and virtual Ethernet module
  B. VMware virtual switch and virtual hosts
  C. the virtual chassis and the virtual line cards
  D. the Cisco Nexus ,1010 and 1,00 Series virtual appliances
  A. the virtual supervisory module and virtual Ethernet module

• Question 12:

  When a switch that supports enhanced zoning joins a fabric, which SW_ILS command does it use to determine the enhanced zoning capabilities of the other switches in the fabric?

  A. MR
  B. ESS
  C. ELP
  D. EFP
  E. none of the above
  C. ELP

• Question 13:

  On a Cisco Nexus 7000 device, on which port type can port security be configured?

  A. Access ports
  B. SPAN destination port
  C. trunk ports
  D. public VLAN-enabled ports
  A. Access ports

• Question 14:

  Which three statements about the configuration of vPC+ are true? (Choose three.)

  A. The FabricPath switch ID must be configured under the vPC domain.
  B. The virtual switch ID of vPC+ must be configured under the FabricPath domain.
  C. On the Cisco Nexus 7000 switch, F1 interfaces must be used as the vPC+ peer links.
  D. The vPC+ peer link must be configured as a Cisco FabricPath core port.
  E. The FabricPath subswitch ID must be configured under the vPC domain.
  F. There has to be atleast 4 virtual switches in the FabricPath domain.
  A. The FabricPath switch ID must be configured under the vPC domain.
  C. On the Cisco Nexus 7000 switch, F1 interfaces must be used as the vPC+ peer links.
  D. The vPC+ peer link must be configured as a Cisco FabricPath core port.

• Question 15:

  Refer to the exhibit.

  

  The network administrator is adding a new Cisco Nexus 1000V Switch to vCenter, but does not see the new switch under the vCenter networking tab. The administrator issues the command that is shown in the exhibit on VSM to troubleshoot this problem. When the administrator attempts to fix the issue, the error that is shown in the exhibit is seen. Which option describes the most correct cause of this error?

  A. There is a missing control VLAN in the VSM configuration.
  B. There is a missing packet VLAN in the VSM configuration.
  C. VSM has no network connection to vCenter.
  D. The VSM extension key is not installed on vCenter.
  E. The vCenter extension key is not installed on VSM.
  D. The VSM extension key is not installed on vCenter.

• Question 16:

  Which two statements about FabricPath are true? (Choose two.)

  A. Multi-destination trees are built to create a loop-free topology for unicast traffic.
  B. FabricPath interfaces send and receive Ethernet and FabricPath encapsulated packets.
  C. FabricPath is supported on Cisco Nexus 7000 on all module types.
  D. FabricPath switch should always be the root for a spanning tree network attached to it.
  E. Spanning tree does not run inside a FabricPath network.
  D. FabricPath switch should always be the root for a spanning tree network attached to it.
  E. Spanning tree does not run inside a FabricPath network.

• Question 17:

  Given a Cisco Unified Computing System, which is a valid port type in end-host mode?

  A. Server
  B. End device
  C. Node
  D. Host
  E. Virtual
  A. Server

• Question 18:

  In a Cisco Unified Computing System, where are SAN port channels connected to?

  A. Only to Cisco Fibre Channel switches
  B. Only to Cisco Fibre Channel switches in NPIV mode
  C. To any Fibre Channel switch
  D. Directly to storage arrays
  E. Only to Nexus Switches
  A. Only to Cisco Fibre Channel switches

• Question 19:

  Which three statements best describe the Cisco Unified Fabric solution for the data center? (Choose three.)

  A. Cisco Nexus 5000 Series Switches provide the capability to consolidate LAN and SAN traffic on a unified fabric over Ethernet.
  B. The unified fabric is delivered throug h technologies such as FCoE and DCB.
  C. FCoE allows transmission of Fibre Channel traffic over Ethernet by encapsulating native Fibre Channel frames into GRE and transporting them across the Ethernet network.
  D. FCoE allows consolidating Fibre Channel traffic from multiple VSANs into the same Ethernet VLAN to be transported across the fabric. PFC ensures lossless transport of the FC traffic over Ethernet.
  E. PFC allows user priorities to be defined on a single physical link, each of which can have its own logical lane that can be paused independently of the others.
  A. Cisco Nexus 5000 Series Switches provide the capability to consolidate LAN and SAN traffic on a unified fabric over Ethernet.
  B. The unified fabric is delivered throug h technologies such as FCoE and DCB.
  E. PFC allows user priorities to be defined on a single physical link, each of which can have its own logical lane that can be paused independently of the others.

• Question 20:

  Refer to the exhibit.

  

  In the figure, the load balancer acts a transparent TCP proxy, and establishes the connection with the client on behalf of the real server. What is this type of spoofing called?

  A. delayed binding
  B. software-based load balancing
  C. transport proxy
  D. application binding
  A. delayed binding