1. Home
  2. Cisco
  3. 350-080

Cisco 350-080 Online Practice Questions and Exam Preparation

350-080 Exam Details

  • Exam Code
    :350-080
  • Exam Name
    :CCIE Data Center Written
  • Certification
    :Cisco Certifications
  • Vendor
    :Cisco
  • Total Questions
    :473 Q&As
  • Last Updated
    :Dec 06, 2021

Cisco 350-080 Online Questions & Answers

  • Question 281:

    Which two statements about the FCIP Write Acceleration feature are true? (Choose two.)

    A. WAN throughput is maximized by minimizing the impact of WAN latency for write operations.
    B. The Write Acceleration feature does not have to be enabled on both sides of the FCIP link.
    C. The FCIP Write Acceleration feature can only be used with multilink port channels if they are constructed with port channel protocol.
    D. The Write Acceleration feature cannot be used across FSPF equal cost paths in FCIP deployments.
    E. The Write Acceleration feature works by immediately returning the SCSI status on the initiator side of the FCIP link.

  • Question 282:

    Which two options correctly display IOM-to-Fabric Interconnect connectivity? (Choose two.)

    A. Option A
    B. Option B
    C. Option C
    D. Option D

  • Question 283:

    Your organization is purchasing Cisco devices as well as non-Cisco devices for switching.

    Which three statements are correct about connecting Cisco devices to a non-Cisco 802.1Q cloud? (Choose three.)

    A. Because Cisco devices transmit BPDUs to the SSTP multicast MAC address on VLANs other than the native VLAN of the trunk, non-Cisco devices do not recognize these frames as BPDUs and flood them on all ports in the corresponding VLAN.
    B. Cisco devices connected to the non-Cisco 802.1Q cloud receive these flooded BPDUs. This BPDU reception allows Cisco switches to maintain a per-VLAN spanning tree topology across a cloud of non-Cisco 802.1Q devices.
    C. The non-Cisco 802.1Q cloud that separates the Cisco devices is treated as a single broadcast segment between all devices connected to the non-Cisco 802.1Q cloud through 802.1Q trunks.
    D. Because Cisco devices transmit BPDUs using the industry standard IEEE 802.1D spanning tree multicast MAC address (01-80-C2-00-00-00), the non-Cisco 802.1Q cloud will seamlessly participate in spanning tree protocol.
    E. Only layer 3 connections will work between Cisco devices and non-Cisco 802.1 cloud.
    F. Additional equipment will be needed to transmit traffic between Cisco devices and non- Cisco 802.1Q cloud direct connectivity is not possible

  • Question 284:

    Where is Cisco UCS vNICs created?

    A. In the blade BIOS
    B. In the operating system
    C. In the service profile
    D. In the card option ROM

  • Question 285:

    You plan to add a new VLAN to your updating service profile template. Assuming that the default maintenance policy is configured, which statement about applying this change is true?

    A. The change will be applied immediately once the blade is rebooted.
    B. The change will be deferred until the user acknowledges.
    C. The change will be applied immediately with no disruption to any bound service profiles.
    D. The change will generate an impact summary message.
    E. The change will require all bound service profiles to be unbound.

  • Question 286:

    SNMPv3 authorizes management operations only by configured users and encrypts SNMP messages. Which authentication protocols does Cisco NX-OS Software use for SNMPv3? (Choose two.)

    A. NMAC-SHA-96 authentication protocol
    B. HMAC-MD5-96 authentication protocol
    C. Community String Match protocol
    D. NMAC-MD5-96 authentication protocol
    E. HMAC-SHA-96 authentication protocol

  • Question 287:

    Which statement describes OTV configuration on the Cisco Nexus 7000 Series Switches?

    A. The OTV control-plane protocol uses the IS-IS protocol to establish adjacencies and exchange MAC reachability across the overlay network. You must enable IS-IS with the feature isis command before OTV adjacencies can be established.
    B. OTV uses an SSM group range for neighbor discovery and to exchange MAC reachability with other OTV edge peers.
    C. The OTV join interface is a routed uplink interface on the edge device used to physically join the overlay network.
    D. The OTV internal interface encapsulates the site Layer 2 frames in IP unicast or multicast packets that are then sent to the other sites.

  • Question 288:

    You can install Cisco DCNM-LAN on a supported version of which two operating systems? (Choose two.)

    A. Microsoft Windows Server
    B. Novell SUSE Linux Enterprise Server
    C. Oracle Enterprise Linux
    D. Red Hat Enterprise Linux
    E. Vmware ESX

  • Question 289:

    A load balancer performs an operation on a predefined parameter, such as the IP address, HTTP cookie, or URL, when a new connection is made so that another connection with the same parameter will always reach the same server. Which load-balancing predictor does this statement describe?

    A. round robin
    B. least-connections
    C. hashing
    D. least-loaded

  • Question 290:

    What are the two FEX connection modes? (Choose two.)

    A. hard-pinning mode
    B. soft-pinning mode
    C. port channel mode
    D. physical-pinning mode
    E. vlan pinning mode

Related Exams:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Cisco exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 350-080 exam preparations and Cisco certification application, do not hesitate to visit our Vcedump.com to find your solutions here.