Cisco 350-080 Online Practice Questions and Exam Preparation

Cisco 350-080 Online Questions & Answers

• Question 291:

  You are about to assign a static UUID to a service profile. This particular UUID is also defined within the range of a UUID pool. The duplicate UUID in the pool has not yet been allocated. What will be the result of applying the static UUID?

  A. Applying the static UUID will fail with an error stating that the UUID exists within a defined resource pool.
  B. Applying the static UUID will succeed with no warnings.
  C. Applying the static UUID will succeed and a minor fault will be raised.
  D. Applying the static UUID will succeed and an information fault will be raised.
  E. Applying the static UUID will fail with an error stating that the UUID is a duplicate UUID.
  B. Applying the static UUID will succeed with no warnings.

• Question 292:

  In a Cisco Nexus 7000 platform configured with GLBP, which GLBP timer can be tuned to prevent unnecessary GLBP state changes during a switchover or ISSU?

  A. GLBP redirect timer
  B. GLBP forwarder pre-empt delay minimum timer
  C. GLBP hold timer
  D. GLBP pre-empt delay minimum timer
  E. GLBP extended hold timer
  F. GLBP nonstop forwarding timer
  E. GLBP extended hold timer

• Question 293:

  Refer to the exhibit.

  

  Assume that the Cisco UCS 6200 Series Fabric Interconnects are equipped with 16 port expansion modules. What is the impact of the last command in the exhibit?

  A. Fabric interconnect B will reboot.
  B. The expansion module on fabric interconnect B will reload.
  C. The command will generate an error.
  D. Both fabric A and B expansion modules will reload.
  E. The expansion module on fabric interconnect B will reload according to the maintenance policy that is set by Cisco UCS Manager.
  C. The command will generate an error.

• Question 294:

  Which three technologies enable lossless Ethernet? (Choose three.)

  A. Priority Flow Control
  B. Enhanced Transmission Selection
  C. Ethernet Credits
  D. Congestion Notification
  E. VLAN-Aware Transmission
  F. IP Type of Server Field
  A. Priority Flow Control
  B. Enhanced Transmission Selection
  D. Congestion Notification

• Question 295:

  Which two statements about a "Virtual PortChannel graceful consistent check" are true?

  A. Graceful consistency check is enabled by default.
  B. When graceful consistency check is enabled, only the links on the secondary peer device are suspended.
  C. Graceful consistency check is disabled by default, so to enable this feature, use graceful consistency-check command under VPC domain configuration mode.
  D. When graceful consistency check is enabled, only the inconsistent VLANs on the secondary peer device are suspended.
  A. Graceful consistency check is enabled by default.
  B. When graceful consistency check is enabled, only the links on the secondary peer device are suspended.

• Question 296:

  After configuring FabricPath, the following message appears in the syslog:

  %STP-2-L2GW_BACKBONE_BLOCK: L2 Gateway Backbone port inconsistency blocking port port-channel100 on VLAN0010.

  What is a possible reason for this message?

  A. Spanning tree must be disabled, and the message indicates that STP is enabled.
  B. STP is misconfigured. The root guard must be disabled.
  C. An inferior BPDU was received on a Cisco FabricPath edge port.
  D. A superior BPDU was received on a Cisco FabricPath edge port.
  D. A superior BPDU was received on a Cisco FabricPath edge port.

• Question 297:

  Refer to the exhibit.

  

  An ESX host is added to a distributed switch but is never seen as a module in VSM. Given below configuration from VSM, what is the cause of this issue? (Choose two.) VSM# show svs domain SVS domain config: Domain iD. 111 Control vlan: 500 Packet vlan: 501 L2/L3 Control modE. L2 L3 control interfacE. NA Status: Config push to VC successful.

  A. Missing VLAN 500 on Switch1 trunk to Switch2
  B. Missing VLAN 501 on Switch1 trunk to Switch 2
  C. VLAN 500 is not created on Switch2
  D. Interface VLAN 500 is missing on Switch1
  E. Interface VLAN 501 is missing on Switch1
  F. VLAN 111 is missing on all switches
  A. Missing VLAN 500 on Switch1 trunk to Switch2
  C. VLAN 500 is not created on Switch2

• Question 298:

  In DCBX feature negotiation, the switch and CNA exchange capability information and configuration values. Which three capabilities are supported in Cisco Nexus 5000 Series Switches? (Choose three.)

  A. PFC
  B. support for logical link up or down
  C. FCoE
  D. multicast
  E. speed
  F. duplex
  A. PFC
  B. support for logical link up or down
  C. FCoE

• Question 299:

  Drag and drop two configurations that could fail without data loss from the left column into the 2 Drives Lost column on the right.

  Select and Place:

  

  

• Question 300:

  Which feature must be enabled on the upstream Fibre Channel switch if the fabric interconnects is configured in end-host mode?

  A. NPV
  B. NPIV
  C. Zoning
  D. Smart Zoning
  B. NPIV