Cisco 350-080 Online Practice Questions and Exam Preparation

Cisco 350-080 Online Questions & Answers

• Question 241:

  Which three statements about the virtual service domain on Cisco Nexus 1000V Switch are true? (Choose three.)

  A. Any traffic coming or going out of the VSD must go through the service virtual machine.
  B. The show virtualservice_domainname command displays the configurations for this VSD port profile.
  C. Service virtual machine only snoops the data and is used for monitoring purposes.
  D. A VSD is collection of interfaces that are guarded by the service virtual machine.
  E. vMotion is supported for the service virtual machine and should not be disabled.
  F. A virtual service domain (VSD) allows you to classify and separate traffic for network services.
  A. Any traffic coming or going out of the VSD must go through the service virtual machine.
  B. The show virtualservice_domainname command displays the configurations for this VSD port profile.
  D. A VSD is collection of interfaces that are guarded by the service virtual machine.

• Question 242:

  Refer to the exhibit.

  

  While attempting to modify a management firmware package, you receive the error that is shown in the exhibit. Which two statements explain this error? (Choose two.)

  A. The management firmware package that is referenced by the service profile has been deleted.
  B. The Cisco UCS Manager version is 2.1 or later.
  C. Cisco Integrated Management Controller firmware should be managed via the host firmware policy.
  D. You cannot modify the management firmware directly when a policy has been assigned.
  E. The user that is logged into Cisco UCS Manager does not have sufficient privileges.
  B. The Cisco UCS Manager version is 2.1 or later.
  C. Cisco Integrated Management Controller firmware should be managed via the host firmware policy.

• Question 243:

  Which statement is true about The QoS Class Fibre Channel?

  A. Cannot be disabled
  B. Cannot have the QoS changed
  C. Can have "Packet Drop" enabled
  D. Is multicast optimized?
  E. Can have the MTU changed
  A. Cannot be disabled

• Question 244:

  Which three statements best describe HSRP configuration on Cisco Nexus switches? (Choose three.)

  A. In a vPC topology, the primary HSRP router will respond to ARP requests, but both HSRP routers will forward data traffic. No additional configuration is required.
  B. In a vPC topology, the primary HSRP router will respond to ARP requests, but both HSRP routers will forward data traffic if the peer-gateway feature is enabled.
  C. You can configure two overlapping HSRP groups to load share traffic from the connected hosts while providing the default router redundancy.
  D. You can use the show standby command to verify HSRP operation and configuration.
  E. If you remove the feature hsrp command, all relevant HSRP configuration information is also removed.
  A. In a vPC topology, the primary HSRP router will respond to ARP requests, but both HSRP routers will forward data traffic. No additional configuration is required.
  C. You can configure two overlapping HSRP groups to load share traffic from the connected hosts while providing the default router redundancy.
  E. If you remove the feature hsrp command, all relevant HSRP configuration information is also removed.

• Question 245:

  Which statement about SAN port channels configured on Cisco Nexus 5000 Series Switches is true?

  A. A single SAN port channel can have both Fibre Channel and virtual Fibre Channel interfaces.
  B. SAN port channels can include up to 16 interfaces.
  C. SAN port channels distribute traffic across all links in the port channel when source ID and destination ID load balancing are used.
  D. The links in SAN port channels can be connected to different sets of switches.
  E. The On mode of operation means ports only operate as part of a SAN port channel or remain inactive.
  E. The On mode of operation means ports only operate as part of a SAN port channel or remain inactive.

• Question 246:

  Refer to the exhibit.

  

  During troubleshooting of Virtual PortChannel (vPC), it is observed that Virtual PortChannel 2 is in a down state. What's the cause of this issue?

  A. Virtual PortChannel is down because LACP is not enabled on the remote switch.
  B. Virtual PortChannel is down because of a VLAN mismatch.
  C. Virtual PortChannel is down because of an MTU mismatch.
  D. Virtual PortChannel is down because of VLAN and MTU mismatch.
  C. Virtual PortChannel is down because of an MTU mismatch.

• Question 247:

  Which three options describe the key management control parameters that Cisco Prime DCNM provides? (Choose three.)

  A. configuration of change control
  B. single shared database for LAN and SAN configuration data
  C. single point for integration with third-party test tools
  D. ability to manage vPCs
  E. autodiscovery of storage controllers
  F. host driver management
  G. support for script automation
  A. configuration of change control
  B. single shared database for LAN and SAN configuration data
  D. ability to manage vPCs

• Question 248:

  Which three statements about Cisco Device Manager Device View are true? (Choose three.)

  A. It can be used to configure zones for multiple VSANs
  B. Can be used toconfigure FC timer values on multiple switches simultaneously.
  C. it can be used to configure virtual Fibre Channel interfaces.
  D. it cannot be used to manage CLI security access to the switch.
  E. It cannot be used to configure Fibre Channel over Ethernet features.
  F. It can be used to manage ports, port channels, and trunking.
  A. It can be used to configure zones for multiple VSANs
  C. it can be used to configure virtual Fibre Channel interfaces.
  F. It can be used to manage ports, port channels, and trunking.

• Question 249:

  Which three options are types of iSCSI node names? (Choose three.)

  A. extended unique identifier
  B. extended qualified name
  C. iSCSI qualified name
  D. network qualified name
  E. iSCSI unique identifier
  F. network address authority
  A. extended unique identifier
  C. iSCSI qualified name
  F. network address authority

• Question 250:

  When using VSD, traffic flow goes from the virtual machine to which of these?

  A. Upstream switch
  B. Virtual Supervisor Module
  C. VMware distributed switch
  D. VMware vSwitch
  E. Service virtual machine
  E. Service virtual machine