Cisco 300-180 Online Practice Questions and Exam Preparation

Cisco 300-180 Online Questions & Answers

• Question 341:

  An administrator wants to combine the advantages of a trunking F port and an F port channel.

  Which command on a Cisco MDS switch should be used to enable this?

  A. enable port-channel
  B. feature trunking-fport
  C. feature fport-channel-trunk
  D. port-channel trunk
  E. feature fport-trunk
  C. feature fport-channel-trunk

• Question 342:

  DRAG DROP

  Drag and drop the types of SPANs from the left onto the correct use cases on the right.

  Select and Place:

  

  

• Question 343:

  Refer to the exhibit.

  

  Which statement accurately described the output?

  A. There are two EPGs associated to the 10.2.2.10 IP address
  B. The displayed endpoint is attached via a vPC.
  C. The displayed endpoint is a local VTEP
  D. There are two endpoints associated to the 10.2.2.10 IP address
  D. There are two endpoints associated to the 10.2.2.10 IP address

• Question 344:

  You have a Cisco UCS Fabric Interconnect in Fibre Channel end-host mode. You must check whether all of the Fibre Channel targets are available through the fabric interconnect at VSAN 200. Which command must you use?

  A. show npvflogi-table
  B. show flogi-table
  C. show flogi database
  D. show zoneset active VSAN 200
  A. show npvflogi-table

• Question 345:

  You receive an error attempting to enable the vPC feature on a Cisco Nexus 7018 Switch. Which Cisco Fabric Services distribution must be operational before the feature can be enabled?

  A. CFSoFC
  B. CFSoIP
  C. CFSoV
  D. CFSoE
  E. CFSoM
  D. CFSoE

• Question 346:

  A leaf is programmed with the correct VLANs and Interfaces, but the servers in web EPG are unreachable from the outside Layer 2 network. You use a unique external L2out EPG as a Layer 2 extension Inside the Cisco ACI fabric. Which action do you take to resolve the communication issue?

  A. Configure an MTU of 9000 bytes on the devices in the L2out EPG
  B. Configure contracts between the web EPG and the L2out EPG
  C. Bind the web EPG to a port/leaf.
  D. Enable a spanning tree on the VLANs on the leaf
  B. Configure contracts between the web EPG and the L2out EPG

• Question 347:

  You must identify and isolate traffic loss. Which option do you configure to monitor EPG-to- EPG traffic within a tenant?

  A. SPAN
  B. traffic map
  C. tcpdump
  D. atomic counters
  A. SPAN

• Question 348:

  You deploy a multihop FCoE network. What must you consider when you configure the vFC ports?

  A. All of the switches in the paths must support vFC type NL ports
  B. All of the switches in the paths must have the same FC-MAP
  C. All of the switches in the paths must support vFC type E ports
  D. All of the switches must have the same VSAN list
  B. All of the switches in the paths must have the same FC-MAP

• Question 349:

  Which can cause a failure of a Cisco UCS Fabric Interconnect uplink to the upstream switch?

  A. a speed mismatch
  B. a CDP version mismatch
  C. a duplex mismatch at a speed of 10 Gbps
  D. an IP address mismatch
  A. a speed mismatch

• Question 350:

  What is the correct configuration for interface Ethernet 1/1 of a Cisco Nexus 5000 Series Switch when it is a member of port channel 101 connected to FEX 101?

  A. interface Ethernet1/1 switchport mode trunk switchport trunk native vlan 10 switchport trunk allowed vlan 20,30 fex associate 101 channel-group 101
  B. interface Ethernet1/1 switchport mode fex-fabric channel-group 101
  C. interface Ethernet1/1 switchport mode access switchport access vlan 10 fex associate 101 channel-group 101
  D. interface Ethernet1/1 switchport mode fex-fabric fex associate 101 channel-group 101
  D. interface Ethernet1/1 switchport mode fex-fabric fex associate 101 channel-group 101