Cisco 300-101 Online Practice Questions and Exam Preparation

Cisco 300-101 Online Questions & Answers

• Question 901:

  How can you minimize unicast flooding in a network?

  A. Configure HSRP on two routers, with one subnet preferred on the first router and a different subnet preferred on the second router.
  B. Set the router's ARP timeout value to be the same as the timeout value for Layer2 forwarding table entries
  C. Set the router's ARP timeout value to greater than the timeout value for Layer 2 forwarding table entries
  D. Set the router's ARP timeout value to less than timeout value for Layer 2 forwarding table entries
  B. Set the router's ARP timeout value to be the same as the timeout value for Layer2 forwarding table entries

• Question 902:

  Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?

  A. A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations.
  B. An automatic 6to4 tunnel allows multiple IPv4 destinations.
  C. A manually configured IPv6 in IPv4 tunnel does not require dual-stack (IPv4 and IPv6) routers at the tunnel endpoints.
  D. An automatic 6to4 tunnel does not require dual-stack (IPv4 and IPv6) routers at the tunnel endpoints
  B. An automatic 6to4 tunnel allows multiple IPv4 destinations.

• Question 903:

  Refer to the exhibit. The command is executed while configuring a point-to-multipoint Frame Relay interface. Which type of IPv6 address is portrayed in the exhibit?

  

  A. link-local
  B. site-local
  C. global
  D. multicast
  A. link-local

• Question 904:

  You have been asked to evaluate an OSPF network setup in a test lab and to answer questions a customer has about its operation. The customer has disabled your access to the show running- config command.

  

  What percent of R1's interfaces bandwidth is EIGRP allowed to use?

  

  How old is the Type 4 LSA from Router 3 for area 1 on the router R5 based on the output you have examined?

  A. 1858
  B. 1601
  C. 600
  D. 1569
  A. 1858

• Question 905:

  What to configure on routes if TACACS+ authentication fails? (Choose two)

  A. Configure local username and password
  B. Include `local' keyword in AAA config
  C. PlaceHolder
  D. PlaceHolder
  A. Configure local username and password
  B. Include `local' keyword in AAA config

• Question 906:

  DRAG DROP Drag and Drop the ACL types from the left onto the correct description on the right

  Select and Place:

  

  

• Question 907:

  How to set up IP SLA to monitor jitter between the certain limits?

  A. Timeout
  B. Frequency
  C. Threshold
  D. Queue-limit
  C. Threshold

• Question 908:

  Which two statements about password-protecting device access are true? (Choose two)

  A. The more system:running-config command displays encrypted passwords in clear text
  B. The service password-encryption command forces a remote device to encrypt the password
  C. A network administrator can recover an encrypted password
  D. The privilege level command controls the commands a specific user can execute
  E. The password can be encrypted in the running configuration
  D. The privilege level command controls the commands a specific user can execute
  E. The password can be encrypted in the running configuration

• Question 909:

  Where to apply ipv6 traffic filter ? (they actually show you possible configuration commands, in interface,global ... modes).

  A. interface configuration
  B. router configuration
  C. global configuration
  D. EXEC mode
  A. interface configuration

• Question 910:

  Which three algorithms can you configure with the ip cef load-sharing algorithm command?(Choose three)

  A. Tunnel
  B. Universal
  C. Include-ports
  D. Source
  E. Destination
  A. Tunnel
  B. Universal
  C. Include-ports