Cisco 300-101 Online Practice Questions and Exam Preparation

Cisco 300-101 Online Questions & Answers

• Question 1001:

  Which feature can be used to reduce the number of ICMP unreachable message egressing a router

  A. uRPF
  B. ICMP rate-limiting
  C. ip unreachables command
  D. Asymmetric routing
  B. ICMP rate-limiting

• Question 1002:

  Which command prevents routers from sending routing updates through a router interface?

  A. default etric 0
  B. distribute-list in
  C. passive-interface
  D. distribute-list out
  C. passive-interface

• Question 1003:

  Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. What did the TAC engineer configure incorrectly?

  

  Select the best response.

  A. The crypto isakmp configuration is not correct.
  B. The crypto map configuration is not correct.
  C. The interface tunnel configuration is not correct.
  D. The network configuration is not correct; network 172.16.1.0 is missing.
  A. The crypto isakmp configuration is not correct.

• Question 1004:

  Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?

  A. dual-stack method
  B. 6to4 tunneling
  C. GRE tunneling
  D. NAT-PT
  A. dual-stack method

• Question 1005:

  In which state do DR and BDR establish adjacency with each ospf router in the network

  A. Exstart State
  B. Loading Sta
  C. Exchange State
  D. Init State
  A. Exstart State

• Question 1006:

  If device R1 has 1-Gigabit and 10-Gigabit Ethernet interfaces, which command do you enter so that it takes full advantage of OSPF costs ?

  A. R1(config-router)#auto-cost reference-bandwidth 10000
  B. R1(config-router)#auto-cost reference-bandwidth 10000000000
  C. R1(config-if)# ip ospf cost 10000000000
  D. R1(config-if)# ip ospf cost 10000
  E. R1(config-route-map)#set metric 10000
  F. R1(config-route-map)#set metric 10000000000
  A. R1(config-router)#auto-cost reference-bandwidth 10000

• Question 1007:

  Which two features are added in MSCHAP Version 2(choose two)

  A. Backwards-compatibility with MSCHAP version 1
  B. Using the MD5 hash for stronger security
  C. Ability to change an expired password
  D. using 3 way handshakes for authentication
  E. mutual authentication between peers
  C. Ability to change an expired password
  E. mutual authentication between peers

• Question 1008:

  Drag and Drop

  You are configuring the R1 Senal0 interface for a point-to-point connection Drag and drop the required configuration statements from the left onto the cooed locations from the diagram on the right. Not all commands are used

  

  Select and Place: