Cisco 300-101 Online Practice Questions and Exam Preparation

Cisco 300-101 Online Questions & Answers

• Question 671:

  The following exhibit shows ipv6 route output. What would the metric be for a summary route that summarizes all three OSPFv3 routes displayed?

  

  A. 160
  B. 140
  C. 120
  D. 100
  D. 100

• Question 672:

  Which three IP SLA performance metrics can you use to monitor enterprise-class networks? (Choose three.)

  A. Packet loss
  B. Delay
  C. bandwidth
  D. Connectivity
  E. Reliability
  F. traps
  A. Packet loss
  B. Delay
  D. Connectivity

• Question 673:

  Which statement about the metric calculation in EIGRP is true?

  A. The maximum delay along the path is used
  B. The mean value of bandwidth between the source and destination is used
  C. The minimum bandwidth between the source and destination is used
  D. The minimum delay along the path is used
  C. The minimum bandwidth between the source and destination is used

• Question 674:

  Refer to the exhibit.

  

  A network administrator checks this adjacency table on a router. What is a possible cause for the incomplete marking?

  A. incomplete ARP information
  B. incorrect ACL
  C. dynamic routing protocol failure
  D. serial link congestion
  A. incomplete ARP information

• Question 675:

  Refer to the exhibit How can you change this configuration so that when user CCNP logs in, the show run command is executed and the session is terminated? aaa new-model aaa authentication login default local-case enable aaa authentication login ADMIN local-case username CCNP secret Str0ngP@ssw0rd! line 0 4 login authentication ADMIN

  A. Add the autocommand keyword to the aaa authentication command
  B. Assign privilege level 15 to the CCNP username
  C. Add the access-class keyword to the aaa authentication command
  D. Assign privilege Ievel14 to the CCNP username
  E. Add the access-class keyword to the username command
  F. Add the autocommand keyword to the username command
  F. Add the autocommand keyword to the username command

• Question 676:

  An engineer is using a network sniffer to troubleshoot DHCPv6 between a router and hosts on the LAN with the following configuration: Interface Ethernet0 Ipv6 dhcp server DHCPSERVERPOOL rapid-commit ! Which two DHCPv6 messages will appear in the snifer logs?

  A. reply
  B. request
  C. advertise
  D. acknowledge
  E. solicit
  F. accept
  A. reply
  E. solicit

• Question 677:

  What command can you enter to configure an enable password that uses an encrypted password from another configuration?

  A. enable secret $abc%!e.Cd34$!ao0
  B. enable secret 7 Sabc%!e.Cd34$!ao0
  C. enable secret 0 Sabc%U*.Cd34$!ao0
  D. enable secret 5 $abc%!e.Cd34$!ao0
  E. enable secret 15 $abc%ie.Cd34$!ao0
  F. enable secret 6 $abc%!e.Cd34$!ao0
  D. enable secret 5 $abc%!e.Cd34$!ao0

• Question 678:

  Redistributing BGP into OSPF what statement is correct? () route-map deny 10 match ip address 10 route-map permit 20 access-list 10 permit 172.16.0.0 0.0.0.255

  A. 172.16.0.0/24 will NOT be redistributed into OSPF
  B. 172.16.0.0/24 will be redistributed into OSPF
  C. Routes permitted by ACL 10 will be redistributed
  D. All routes will be filtered
  A. 172.16.0.0/24 will NOT be redistributed into OSPF

• Question 679:

  In IPv6, SLAAC provides the ability to address a host based on a network prefix that is advertised from a local network router. How is the prefix advertised?

  A. routing table
  B. router advertisements
  C. routing protocol
  D. routing type
  B. router advertisements

• Question 680:

  Which of the following SNMPv2 uses for authentication?

  A. HMAC-MD5
  B. HMAC-SHA
  C. CBC-DES
  D. Community strings
  D. Community strings