HP HP2-T25 Online Practice
Questions and Exam Preparation
HP2-T25 Exam Details
Exam Code
:HP2-T25
Exam Name
:Servicing HP Rack-Tower Server Solutions
Certification
:HP Certifications
Vendor
:HP
Total Questions
:76 Q&As
Last Updated
:Dec 11, 2021
HP HP2-T25 Online Questions &
Answers
Question 41:
When populating memory slots in a DL380 G7 server, which rule must be followed?
A. Use white DIMM slots first with installed processors. B. Only one 16 GB PC3-10600 DIMM per channel is allowed. C. PC3L DIMMs must precede PC3 DIMMs in physical location. D. Install DIMMs starting with the nearest slot to the processor.
A. Use white DIMM slots first with installed processors.
DIMM slots that are white should be populated first.
Question 42:
Where can the server PSP be chosen for version comparison and updates?
A. VCEM B. SIM VCRM C. SMH D. VCA
D. VCA
The Version Control Agent (VCA) is an HP Insight Management Agents that is installed on a server to enable you to see the HP software and firmware that is installed on that server.
Note:
* ProLiant Support Packs (PSP) represent operating system (OS) specific bundles of optimized drivers, utilities, and management agents. These bundles are tested together to ensure proper installation and functionality. PSPs are released concurrently with HP's SmartStart, and can also be released outside of the SmartStart cycle and made available on the HP ProLiant Support Pack download selection pages or at HP Insight Foundation website.
Question 43:
Indicate whether each listed component requires downtime during the DL380p G8 upgrade process.
Hot Area:
Question 44:
A customer asks you to check on the remaining life of the solid state disk drives. Where can you access the SMARTSSD Wear Gauge?
A. Array Configuration Utility (ACU) B. iLO home page C. Option ROM Configuration for Arrays (ORCA) D. Integrated Management log (IML)
A. Array Configuration Utility (ACU)
Array configuration utility
ACU is a browser-based utility which include the following feature:
* Provides diagnostic and SmartSSD Wear Gauge functionality on the Diagnostics tab
Question 45:
A support engineer is attending a call out for a DL360P Gen8 Server, where a hard disk within a four disk RAID 5 set has failed. The engineer notices that on three of the drives, the LED labeled D on the exhibit is on.
What does the condition indicate?
A. Hot swapping of the failed drive is not supported in this condition. B. The LED indicates both failure and predictive failure alerts; therefore, two additional drives in the RAID set are at risk of failing and need to be replaced. C. The drive failure has corrupted three drives in the RAID set. The array will need to be rebuilt and data restored from backup. D. Do not remove the drives with this LED on.
D. Do not remove the drives with this LED on.
Drive LED definitions
* Do not remove / Solid white Do not remove the drive. Removing the drive causes one or more of the logical drives to fail. / Off Removing the drive does not cause a logical drive to fail.
Question 46:
Which RAID level is known as Advance Data Guarding (ADG)?
A. RAID 1 B. RAID 5 C. RAID 6 D. RAID 10
C. RAID 6
RAID 6 with HPs patented Advanced Data Guarding (ADG) technology is a cost-effective solution for storing large volumes of enterprise data with fault tolerance. Its performance, like that of other RAID levels, depends on the nature of the application. Organizations implementing a large drive array should consider RAID 6 because it can tolerate up to two simultaneous drive failures without downtime or data loss.
Question 47:
A memory DIMM of an HP Integrity rx2800 i2 server failed and was deconfigured. You replaced it. Which statement is correct?
A. The new memory DIMM will still be deconfigured. You have to reconfigure it with the UEFI memconfig command. B. The new memory DIMM will be reconfigured automatically by the firmware. There is no command at UEFI shell to configure DIMMs. C. The new memory DIMM will still be deconfigured. You have to reconfigure it with the UEFI dimmconfig command. D. The new memory DIMM will be reconfigured automatically by the firmware. You can use the UEFI dimmconfig command to check and configure DIMMs. E. The new memory DIMM will be reconfigured automatically by the firmware. You can use the UEFI memconfig command to check and configure DIMMs.
E. The new memory DIMM will be reconfigured automatically by the firmware. You can use the UEFI memconfig command to check and configure DIMMs.
While the system is online and the OS is operating, the HP Insight Diagnostics Diagnose feature performs diagnostics testing on which devices?
A. network interface cards only B. memory and processors only C. hard drives attached to an HP Smart array Controller and power supplies considered diagnosable D. memory, processors, and network interface cards
C. hard drives attached to an HP Smart array Controller and power supplies considered diagnosable
Using the Diagnose tab
While the system is online and the OS is operating, the HP Insight Diagnostics Diagnose feature performs diagnostics testing on the following devices:
*
Hard drives attached to an HP Smart Array Controller
*
Power supplies that are deemed diagnosable
Question 49:
What is the term that describes the full backup typically performed by a system administrator every week?
A. grandfather, father, son B. fathers C. grandmothers D. sons
A. grandfather, father, son
GRANDFATHER-FATHER-SON BACKUP STRATEGY
GFS (grandfather, father, son) is a tape rotation strategy. GFS simplifies tape handling by organizing rotation into daily, weekly, and monthly backup tapes. You can also create Custom backup jobs that use the GFS strategy.
Question 50:
A customer has an HP Integrity rx2800 i2 server with one processor and two memory risers, each with four DIMMs. The customer added an additional memory riser with four memory DIMMs, but cannot see the additional memory at the
operating system level. The customer already swapped the first memory riser with the new one, but there is no change.
What could cause this issue?
A. One of the new DIMMs is faulty. B. The new memory riser is faulty. C. An additional license is needed for using more than two memory risers. D. An additional processor is needed for using more than two memory risers.
C. An additional license is needed for using more than two memory risers.
*The DIMMs are partitioned by the number of processors installed in the server. If you have only one processor installed in the system, you can only use 12 of the 24 memory slots. *
Nowadays, the certification exams become more and more important and required by more and more
enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare
for the exam in a short time with less efforts? How to get a ideal result and how to find the
most reliable resources? Here on Vcedump.com, you will find all the answers.
Vcedump.com provide not only HP exam questions,
answers and explanations but also complete assistance on your exam preparation and certification
application. If you are confused on your HP2-T25 exam preparations
and HP certification application, do not hesitate to visit our
Vcedump.com to find your solutions here.