Cisco 350-601 Online Practice Questions and Exam Preparation

Cisco 350-601 Online Questions & Answers

• Question 331:

  DRAG DROP

  Refer to the exhibit.

  The traffic flow from the storage device fails to communicate with the DB-Pod device.

  The engineer must configure a monitoring feature to analyze the issue.

  Drag and drop the configuration snippets from the bottom onto the boxes on the top to deploy the monitoring feature on MDS97K.

  Not all commands are used. Not all options are used.

  Select and Place:

  

  

• Question 332:

  Which statement describes the rolling EPLD upgrade on a Cisco MDS 9000 Series Switch?

  A. The standby supervisor module is capable of performing the upgrade.
  B. Only the modules that are being upgraded are disrupted.
  C. All modules on the switch are disrupted.
  D. An EPLD upgrade is nondisruptive.
  B. Only the modules that are being upgraded are disrupted.

• Question 333:

  An engineer implements an environment with multiple traffic types on a consolidated I/O link between Cisco Nexus 9000 Series Switch and MDS 9000 Series Switch. The configuration must meet these requirements:

  1. The unified I/O link must support LAN and SAN traffic.

  2. A single, multipurpose Ethernet transport must be used.

  3. The configuration must discard MAC addresses that are not part of the current fabric.

  4. The QoS markings must be preserved.

  Which configuration set meets the requirements?

  A. MDS-A(config)# interface fcip4 MDS-A(config-if)# use-profile 8 MDS-A(config-if)# peer-info ipaddr 200.200.100.7
  B. N9K-2(config)# interface Eth2 N9K-2(config-if)# switchport mode trunk N9K-2(config-if)# auto qos trust dscp
  C. MDS-B(config)# interface fc3 MDS-B(config-if)# switchport trunk mode on MDS-B(config-if)# switchport trunk allowed vsan 2-5
  D. N9K-1(config)# fcoe fcmap 0e.fc.1d N9K-1(config)# int vfc 1 N9K-1(config-if)# bind interface e1/3
  D. N9K-1(config)# fcoe fcmap 0e.fc.1d N9K-1(config)# int vfc 1 N9K-1(config-if)# bind interface e1/3

  ---

  
  

• Question 334:

  Refer to the exhibit.

  

  Server1 is connected to a Cisco Nexus 9000 Series Switch via a 1-Gb port channel. The storm control is applied to the Eth0 device with a zero percent value.

  What does the switch do to traffic that traverses the switch interfaces during the streaming window that exceeds the bandwidth of the interfaces?

  A. forwards all traffic
  B. forwards half of the traffic
  C. suppresses all traffic
  D. drops all of the excess traffic
  C. suppresses all traffic

• Question 335:

  When deploying a Cisco HyperFlex edge with a pair of switches, what is the minimum number of interfaces in trunk mode required on each HX node?

  A. 1
  B. 2
  C. 4
  D. 6
  B. 2

• Question 336:

  Refer to the exhibit.

  

  Which statement about the default gateway configuration of the vPC is true?

  A. N7K-1 acts as the default gateway for all traffic.
  B. N7K-2 forwards traffic that is destined for the default gateway by using the peer link.
  C. N7K-2 acts as the default gateway for all traffic.
  D. Either switch can act as the active default gateway.
  D. Either switch can act as the active default gateway.

  ---

  Explanation

  https://community.cisco.com/t5/networking-documents/peer-gateway-feature-on-the-nexus-7000/ta-p/3113290

• Question 337:

  Refer to the exhibit.

  

  Which VLANs are capable to be assigned on vPC interfaces?

  A. 100-103
  B. 100-104
  C. 100-102
  D. 100-105
  D. 100-105

• Question 338:

  Refer to the exhibit. An engineer runs a Python script from a newly enabled guest shell on a Cisco Nexus 93108 Series Switch. The script needs an additional package called "Markdown" installed from the Python package manager.

  Which set of tasks must the engineer perform to install the required package?

  

  A. Set the NAMESERVER variable in /etc/sysconfig/network. Clone the Markdown repository with the git clone command.
  B. Add nameserver configuration to /etc/resolv.conf. Run sudo chvrf management pip install Markdown.
  C. Enable ip domain-lookup in startup-config. Enter python install Markdown as root.
  D. Configure ip name-server in configuration mode. Execute sudo yum -y install Markdown.
  B. Add nameserver configuration to /etc/resolv.conf. Run sudo chvrf management pip install Markdown.

• Question 339:

  Refer to the exhibit.

  

  An engineer must distribute all the host ports to use all eight configured FEX uplinks. The solution must minimize disruption if an uplink fails.

  Which action accomplishes this objective?

  A. Configure the eight uplinks in a port channel.
  B. Change the supported FEX type.
  C. Set the pinning max-links value to 8.
  D. Statically assign each host interface to a fabric uplink.
  A. Configure the eight uplinks in a port channel.

  ---

  Explanation

  A fabric interface that fails in the port channel does not trigger a change to the host interfaces. Traffic is automatically redistributed across the remaining links in the port channel fabric interface. If all links in the fabric port channel go down, all host interfaces on the FEX are set to the down state.

• Question 340:

  Which three firmware packages are included in the Cisco UCS C-Series Rack-Mount UCS-Managed Server Software bundle? (Choose three.)

  A. CIMC
  B. board controller
  C. system
  D. third-party
  E. BIOS
  F. adapter
  A. CIMC
  E. BIOS
  F. adapter