Cisco 300-101 Online Practice Questions and Exam Preparation

Cisco 300-101 Online Questions & Answers

• Question 601:

  Which two types of threshold are configured for tracking object? (Choose two)

  A. delay
  B. percentage
  C. bandwidth
  D. administrative distance
  E. weight
  B. percentage
  E. weight

• Question 602:

  Which task must you perform to implement EIGRP for IPv6 on a device?

  A. Use the ipv6 cef command to enable Cisco Express Forwarding on the device.
  B. Configure a loopback interface on the device.
  C. Manually configure the router ID
  D. Statically configure a neighbor statement
  C. Manually configure the router ID

• Question 603:

  A network engineer receives reports about poor voice quality issues at a remote site. The network engineer does a packet capture and sees out-of-order packets being delivered. Which option can cause the VoIP quality to suffer?

  A. speed duplex link issues B. misconfigured voice VLAN
  C. load balancing over redundant links
  D. traffic over backup redundant links
  C. load balancing over redundant links

• Question 604:

  Which are two methods for migrating routing protocols?(Choose Two)

  A. Changing AD Distance
  B. Redistribution
  C. ACL
  D. PlaceHolder
  A. Changing AD Distance
  B. Redistribution

• Question 605:

  A network engineer wants to ensure an optmal end-to-end delay bandwidth product. The delay is less than 64KB. Which TCP feature ensures steady state throughput?

  A. Window scaling
  B. Network buffer
  C. Round-trip timers
  D. TCP acknowledgments
  A. Window scaling

• Question 606:

  DRAG DROP

  Refer to the exhibit.

  

  You are configuring the R1 Serial0 interface for a point-to-point connection. drag and drop the required configuration statements from the left onto the correct locations from the diagram on the right. Not all commands are used.

  Select and Place:

  

  

• Question 607:

  A network engineer executes the show ip flow export command. Which line in the output indicates that the send queue is full and export packets are not being sent?

  A. output drops
  B. enqueuing for the RP
  C. fragmentation failures
  D. adjacency issues
  A. output drops

• Question 608:

  Which two BGP neighbor states are valid? (Choose two)

  A. established
  B. active
  C. stuck in active
  D. 2-WAY
  E. unknown
  F. PlaceHolder
  A. established
  B. active

• Question 609:

  Question about IP SLA deployment cycle. Chose best IP SLA deployment cycle that reduce deployment. ( Choose Three)

  A. Baseline Network performance
  B. Understand Quality results
  C. Fine tune and simplify
  D. Quality results.
  E. Etc...
  A. Baseline Network performance
  C. Fine tune and simplify
  D. Quality results.

• Question 610:

  Which two functionalities are specific to stateless NAT64? (Choose two.)

  A. No requirement exists for the characteristics of Ipv6 address assignment
  B. It does not conserve Ipv4 addresses
  C. It provides 1-to-1 translation
  D. It uses address overloading.
  E. State or bindings are created on the translation.
  B. It does not conserve Ipv4 addresses
  C. It provides 1-to-1 translation