Cisco 300-101 Online Practice Questions and Exam Preparation

Cisco 300-101 Online Questions & Answers

• Question 321:

  Which two statements are differences between AAA with TACACS+ and AAA with RADIUS? (Choose two)

  A. Only RADIUS uses TCP
  B. Unlike TACACS+, RADIUS sends packets with only the password encrypted
  C. Unlike TACACS+, RADIUS supports accounting and authorization only
  D. Only TACACS+ uses TCP
  E. Only TACACS+ combines authentication and authorization
  B. Unlike TACACS+, RADIUS sends packets with only the password encrypted
  D. Only TACACS+ uses TCP

• Question 322:

  You want the devices on your network to summarize routes between OSPF areas. Which action must you take?

  A. Configure the area range command on the ABR.
  B. Configure the summary-address command on the ABR.
  C. Configure the area range command on the ASBR.
  D. Configure the summary-address command on the ASBR.
  D. Configure the summary-address command on the ASBR.

• Question 323:

  A network engineer notices that transmission rates of senders of TCP traffic sharply increase and decrease simultaneously during periods of congestion. Which condition causes this?

  A. global synchronization
  B. tail drop
  C. random early detection
  D. queue management algorithm
  A. global synchronization

• Question 324:

  Which adverse event can occur as a consequence of asymmetric routing on the network?

  A. vulnerability to a man-in the - middle atack
  B. inadventent HSRP active router preemption
  C. errdisabled port
  D. unicast flooding
  D. unicast flooding

• Question 325:

  Under which circumstance can TCP starvation occur?

  A. when DNS and TFTP traffic are transmitted on the same link
  B. when TCP traffic is blocked by an ACL
  C. when UDP traffic is processed in a policy-map before TCP traffic
  D. when Http and Https traffic are transmitted on the same link
  E. when TCP and UDP traffic are mixed in the same class of service
  E. when TCP and UDP traffic are mixed in the same class of service

• Question 326:

  Which address is used by the Unicast Reverse Path Forwarding protocol to validate a packet against the routing table?

  A. source address
  B. destination address
  C. router interface
  D. default gateway
  A. source address

• Question 327:

  Observe the exhibit.

  

  If the command variance 3 were added to RTE, which path or paths would be chosen to route traffic to network X?

  A. E-B-A
  B. E-B-A and E-C-A
  C. E-C-A and E-D-A
  D. E-B-A, E-C-A and E-D-A
  B. E-B-A and E-C-A

• Question 328:

  ALWAYS block the outbound web traffic on Saturdays and Sunday between 1:00 to 23:59

  A. periodic Saturday Sunday 01:00 to 23:59 and IN
  B. periodic Saturday Sunday 01:00 to 23:59 and OUT
  C. periodic Saturday Sunday 01:00 to 11:59 and IN
  D. Absolute Saturday Sunday 01:00 to 11:59 and IN
  B. periodic Saturday Sunday 01:00 to 23:59 and OUT

• Question 329:

  Engineer has to enable RIP on a link. Where he will issue the command?

  A. Ipv6
  B. Global
  C. Router sub command
  D. Interface subcommand
  C. Router sub command

• Question 330:

  For security purposes, an IPv6 traffic filter was configured under various interfaces on the local router. However, shortly after implementing the traffic filter, OSPFv3 neighbor adjacencies were lost. What caused this issue?

  A. The traffic filter is blocking all ICMPv6 traffic.
  B. The global anycast address must be added to the traffic filter to allow OSPFv3 to work properly.
  C. The link-local addresses that were used by OSPFv3 were explicitly denied, which caused the neighbor relationships to fail.
  D. IPv6 traffic filtering can be implemented only on SVIs.
  C. The link-local addresses that were used by OSPFv3 were explicitly denied, which caused the neighbor relationships to fail.