Cisco 300-101 Online Practice Questions and Exam Preparation

Cisco 300-101 Online Questions & Answers

• Question 341:

  

  R1 and R2 are unable to establish an EIGRP adjacency. Which action corrects the problem?

  A. Change the eigrp route-id on one of the routers so that values on the two routers are diffrent
  B. Add the no auto-summary command to the R2 configuration so that it matches the R1 connfiguration
  C. Change the autonomous system number on one of the routers so that each router has diffrerent values
  D. Change the IP address and subnet mask on R2 so that is on the same subnet as R1.
  D. Change the IP address and subnet mask on R2 so that is on the same subnet as R1.

• Question 342:

  What is the maximum number of hops on a router that RIPng advertises as reachable?

  A. 15
  B. 30
  C. 99
  D. 255
  A. 15

• Question 343:

  Which statement about conditional debugging is true?

  A. It can support only one condition at a time
  B. You can limit the output to a specific interface
  C. It generates debug messages only for packets entering the router
  D. It is limited to Erhernet, serial, and multilink interfaces
  B. You can limit the output to a specific interface

• Question 344:

  Which two actions must you perform to enable and use window scaling on a router?(Choose two.)

  A. Execute the command ip tcp window-size 65536.
  B. Set window scaling to be used on the remote host.
  C. Execute the command ip tcp queuemax.
  D. Set TCP options to "enabled" on the remote host
  E. Execute the command ip tcp adjust-mss.
  A. Execute the command ip tcp window-size 65536.
  B. Set window scaling to be used on the remote host.

• Question 345:

  Which protocol proposes IETF as the viable successor to NAT-PT?

  A. NAT64
  B. 64 NAT
  C. NAT-PT64
  D. 64NAT-PT
  A. NAT64

• Question 346:

  Under which circumstance can flooding occur in a Layer 2 network?

  A. when the source MAC address is missing from the Layer 2 forwarding table
  B. when the destination MAC address is present only in the TCAM table of one of the destination switches
  C. when the destination MAC address is present only in the TCAM table on the local switch
  D. when the destination MAC address is missing from the Layer 2 forwarding table
  D. when the destination MAC address is missing from the Layer 2 forwarding table

• Question 347:

  Refer to the exhibit. Which option describes why the EIGRP neighbors of this router are not learning routes that are received from OSPF?

  

  A. The subnet defined in OSPF is not part of area 0.
  B. Default metrics are not configured under EIGRP.
  C. There is no overlap in the subnets advertised.
  D. The routing protocols do not have the same AS number.
  B. Default metrics are not configured under EIGRP.

• Question 348:

  Drag and Drop

  Drag and drip the IPv6 NAT characteristic from the left into the correct IPv6 NAT category to the right.

  Select and Place:

  

  

• Question 349:

  Refer to Exhibit. Which two reasons for IP SLA tracking failure are likely true? (Choose Two.)

  

  A. The source-interface is configured incorrectly.
  B. The destination must be 172.30.30.2 for icmp-echo.
  C. A route back to the R1 LAN network is missing in R2.
  D. The default route has wrong next hop IP address.
  E. The threshold value is wrong.
  A. The source-interface is configured incorrectly.
  C. A route back to the R1 LAN network is missing in R2.

• Question 350:

  WHich DHCP option provides a TFTP server that Cisco phones can use to download a configuration?

  A. DHCP Option 66
  B. DHCP Option 68
  C. DHCP Option 82
  D. DHCP Option 57
  A. DHCP Option 66