Cisco 300-101 Online Practice Questions and Exam Preparation

Cisco 300-101 Online Questions & Answers

• Question 161:

  A network engineer wants to display the statistics of an active tunnel on a DMVPN network. Which command should the administrator execute to accomplish this task?

  A. Router#show crypto ipsec sa
  B. Router#show crypto isakmp peers
  C. Router#show crypto isakmp sa
  D. Router#show crypto ipsec transform-set
  E. Router#show crypto engine connections active
  A. Router#show crypto ipsec sa

• Question 162:

  Drag and Drop

  Select and Place:

  

  

• Question 163:

  Which two attributes describe UDP within a TCP/IP network? (Choose two.)

  A. Acknowledgments
  B. Unreliable delivery
  C. Connectionless communication
  D. Connection-oriented communication
  E. Increased headers
  B. Unreliable delivery
  C. Connectionless communication

• Question 164:

  When unicast reverse path forwarding is configured on an interface, which action does the interface take first when it receives a packet?

  A. it verifies that the source has a valid VEF adjacency.
  B. It checks the egress access lists.
  C. it verifies a reverse path via the FIB to the source.
  D. It checks the ingress access lists.
  C. it verifies a reverse path via the FIB to the source.

• Question 165:

  Drag and drop the methods supported by the aaa accounting command from the left onto the correct descriptions on the right.

  Select and Place:

  

  

• Question 166:

  DHCPv6 can obtain configuration parameters from a server though rapid two-way message exchange.Which two steps are involved in this process?(choose two)

  A. advertise
  B. solicit
  C. reply
  D. request
  E. auth
  B. solicit
  C. reply

• Question 167:

  Which functionality is required within an IP router that is situated at the boundary of an IPv4 network and an IPv6 network to allow communication between IPv6-only and IPv4-only nodes?

  A. Autoconfiguration
  B. Automatic 6to4 Tunnel
  C. Automatic 6to4 Relay
  D. Network Address Translator-Protocol Translator (NAT-PT)
  E. Intrasite Automatic Tunnel Address Protocol (ISATAP)
  D. Network Address Translator-Protocol Translator (NAT-PT)

• Question 168:

  A company's corporate policy has been updated to require that stateless, 1-to-1, and IPv6 to IPv6 translations at the Internet edge are performed. What is the best solution to ensure compliance with this new policy?

  A. NAT64
  B. NAT44
  C. NATv6
  D. NPTv4
  E. NPTv6
  E. NPTv6

• Question 169:

  Which type of information is displayed when a network engineer executes the show track 1 command on the router?

  A. information about tracking list 1
  B. information about the IP route track table.
  C. time to next poll for track object 1
  D. tracking information statistics.
  A. information about tracking list 1

• Question 170:

  Refer to the exhibit.

  Show config on R2.

  After you apply this configuration to router R1, it fails to establish an EBGP neighbor relationship with R2. Which action do you take to correct the problem?

  A. Configure the update-source for 10.1.1.2
  B. Change the ebgp-multihop value to 1.
  C. Add the no synchronization statement at the end of the configuration
  D. Replace the maximum-paths command at the end of the configuration with maximum-paths ibgp 4 import 2.
  A. Configure the update-source for 10.1.1.2