Cisco 300-101 Online Practice Questions and Exam Preparation

Cisco 300-101 Online Questions & Answers

• Question 131:

  A network engineer execute the show ip cache flow command. Which two types of information are displayed in the report that is generated? (Choose two)

  A. MLS flow traffic
  B. flow samples for specific protocols
  C. IP packets distribution flow expert statistic
  D. top takers
  B. flow samples for specific protocols
  D. top takers

• Question 132:

  regarding command the enables BGP to support multiprotocol

  A. no bgp default ipv4 unicast
  B. bgp default ipv4 multicast
  C. bgp default ipv4 unicast
  D. bgp address family ipv4 unicast
  A. no bgp default ipv4 unicast

• Question 133:

  What is show on logging console 7?

  A. Debugging and all above level
  B. Information and all above level
  C. Error and all above level
  D. Emergencies and all above level
  A. Debugging and all above level

• Question 134:

  Drag and Drop

  Click and drag the correct techniques for transitioning networks or devices from IPv4 to IPv6 from the left to the target zone on the right.

  Select and Place:

  

  

• Question 135:

  What is the purpose of configuring the router as a PPPoE client? Select the best response.

  A. To provide VPN access over L2TP
  B. To enable PPP session from the router to the termination device at the headend for metro Ethernet connectivity
  C. For DSL connectivity and removing the need for the end-user PC to run the PPPoE client software
  D. For connecting the router to a cable modem, which bridges the Ethernet frames from the router to the cable modem termination system
  C. For DSL connectivity and removing the need for the end-user PC to run the PPPoE client software

• Question 136:

  What's uRPF checking first when the packet enters the interface ? or when unicast reverse patch forwarding is configured on interinterface.

  A. it check the ingress access list
  B. it check the egress access list
  C. Route available in FIB ot it verifies a reverse patch via the fib to the source
  D. It verifies that the source has a valid CEF adjacency
  C. Route available in FIB ot it verifies a reverse patch via the fib to the source

• Question 137:

  methods for migrating routing protocols(choose two)

  A. Changing AD distance
  B. Redistribution
  C. ACL
  D. NAT
  A. Changing AD distance
  B. Redistribution

• Question 138:

  Which two types of threshold can you configure for tracking objects? (Choose Two)

  A. percentage
  B. MTU
  C. bandwidth
  D. weight
  E. delay
  F. administrative distance
  A. percentage
  D. weight

• Question 139:

  A network engineer replaced a bad router with a spare, used router in an OSPF network. After the replacement, OSPF neighborship is not being established on one of the interfaces. Which two reasons cause this issue? (Choose two)

  A. authentication mismatch 0 MTU mismatch
  B. OSPF process numbers do not match on both neighbor routers.
  C. OSPF timers match
  D. area numbers match
  B. OSPF process numbers do not match on both neighbor routers.
  C. OSPF timers match

• Question 140:

  IPv6 has just been deployed to all of the hosts within a network, but not to the servers.Which feature allows IPv6 devices to communicate with IPv4 servers?

  A. NAT
  B. NATng
  C. NAT64
  D. dual-stack NAT
  E. DNS64
  C. NAT64