Cisco 100-105 Online Practice Questions and Exam Preparation

Cisco 100-105 Online Questions & Answers

• Question 711:

  Which syslog severity level logs information messages?

  A. 2
  B. 6
  D. 4
  B. 6

• Question 712:

  DRAG DROP

  Drag and drop each feature on the left on to the correct routing type on the right.

  Select and Place:

  

  

• Question 713:

  DRAG DROP

  Drag and drop the logging configuration commands from the left onto the logging locations they configure on the right.

  Select and Place:

  

  

• Question 714:

  Which information is missing from a default syslog message?

  A. HOSTNAME
  B. SEVERITY
  C. MESSAGE
  D. TIMESTAMP
  A. HOSTNAME

• Question 715:

  A workstation has just resolved a browser URL to the IP address of a server. Which protocol will the workstation now use to determine the destination MAC address to be placed into frames directed toward the sever?

  A. ARP
  B. RARP
  C. DNS
  D. DHCP
  E. HTTP
  A. ARP

• Question 716:

  Which of the following used to identify the immediate destination?

  A. Administrative distance
  B. Metric
  C. Next hop
  D. Destination network
  C. Next hop

• Question 717:

  What disables CEF?

  A. RIB
  B. IPv6
  C. Ping
  D. Disable Logging
  D. Disable Logging

• Question 718:

  If router R1 knows a static route to a destination network and then learns about the same destination network through a dynamic routing protocol, how does R1 respond?

  A. It refuses to advertise the dynamic route to other neighbors
  B. It sends a withdrawal signal to the neighboring router
  C. It disables the routing protocol
  D. It prefers the static route
  D. It prefers the static route

• Question 719:

  Refer to the exhibit.

  

  All devices attached to the network are shown. Which number of collision domains are present in this network?

  A. 9
  B. 3
  C. 6
  D. 2
  E. 15
  E. 15

• Question 720:

  Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.) Router(config)# router ospf 1

  A. All OSPF routers in an area must have the same process ID.
  B. Only one process number can be used on the same router.
  C. Different process identifiers can be used to run multiple OSPF processes.
  D. The process number can be any number from 1 to 65,535.
  E. Hello packets are sent to each neighbor to determine the processor identifier.
  C. Different process identifiers can be used to run multiple OSPF processes.
  D. The process number can be any number from 1 to 65,535.