Cisco 100-105 Online Practice Questions and Exam Preparation

Cisco 100-105 Online Questions & Answers

• Question 701:

  A host is attempting to communicate with a server from an application layer. The connection has failed, what would be the first layer to start from the troubleshooting standpoint?

  A. network
  B. Application
  C. physical
  D. session
  C. physical

• Question 702:

  

  What is the bandwidth on the WAN interface of Router1?

  A. 16 Kbit/sec
  B. 32 Kbit/sec
  C. 64 Kbit/sec
  D. 128 Kbit/sec
  E. 512 Kbit/sec
  F. 1544 Kbit/sec
  A. 16 Kbit/sec

• Question 703:

  Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?

  

  A. 10.1.1.2
  B. 10.154.154.1
  C. 172.16.5.1
  D. 192.168.5.3
  C. 172.16.5.1

• Question 704:

  Refer to the exhibit. A technician is troubleshooting a host connectivity problem. The host is unable to ping a server connected to Switch_A. Based on the results of the testing, what could be the problem?

  

  A. A remote physical layer problem exists.
  B. The host NIC is not functioning.
  C. TCP/IP has not been correctly installed on the host.
  D. A local physical layer problem exists.
  D. A local physical layer problem exists.

• Question 705:

  Which symbol ping of the following is for unknown packet?

  A. .
  B. *
  C. ?
  D. U
  C. ?

• Question 706:

  Which subnet mask allows for up to 126 hosts in a single Layer 2 domain?

  A. 255.255.128.0
  B. 255.255.255.0
  C. 255.255.255.128
  D. 255.255.255.224
  C. 255.255.255.128

• Question 707:

  Which two statements about IPv6 SLAAC are true? (Choose two.)

  A. The default gateway of the host is configured during the SLAAC process.
  B. It is incompatible with DHCP.
  C. The host uses the EUI-64 algorithm to calculate the first 64 bits of the destination IPv6 address from the MAC address.
  D. It has a built-in mechanism to identify duplicate IP addresses on the network.
  E. The host sends a router advertisement message to begin the SLAAC process.
  A. The default gateway of the host is configured during the SLAAC process.
  D. It has a built-in mechanism to identify duplicate IP addresses on the network.

• Question 708:

  Refer to the output of the three router commands shown in the exhibit. A new technician has been told to add a new LAN to the company router. Why has the technician received the error message that is shown following the last command?

  

  A. The interface was already configured.
  B. The interface type does not exist on this router platform.
  C. The IOS software loaded on the router is outdated.
  D. The router does not support LAN interfaces that use Ethernet.
  E. The command was entered from the wrong prompt.
  B. The interface type does not exist on this router platform.

• Question 709:

  You are configuring dynamic NAT on your Cisco IOS router. Which command is used to verify the interfaces that are being used as the outside interface and the inside interface?

  A. show interfaces
  B. show ip route
  C. show ipnat translations
  D. show ip interface brief
  E. show ip interface
  F. show ip nat statistics
  F. show ip nat statistics

• Question 710:

  Which two security appliances will you use in a network? (Choose two.)

  A. ATM
  B. IDS
  C. IOS
  D. IOX
  E. IPS
  F. SDM
  B. IDS
  E. IPS