Juniper JN0-360 Online Practice Questions and Exam Preparation

Juniper JN0-360 Online Questions & Answers

• Question 111:

  Click the Exhibit button.

  

  Based on the configuration shown in the exhibit, what will be the state of the IS-IS levels on interface ge-0/0/0.100?

  A. Level 1 is enabled and Level 2 is disabled.
  B. Level 1 is disabled and Level 2 is enabled.
  C. Level 1 is enabled and Level 2 is enabled.
  D. Level 1 is disabled and Level 2 is disabled.
  D. Level 1 is disabled and Level 2 is disabled.

• Question 112:

  Click the Exhibit.

  

  Referring to the configuration in the exhibit, which statement is true?

  A. The next-hop 172.16.1.2 must be directly connected to the router for route 192.168.5.0/24 to be active.
  B. The next-hop 172.16.1.2 must be part of an active route in route table inet.0 for route 192.168.5.0/24 to be active.
  C. The next-hop 172.16.1.2 must respond to ping commands for the route 192.168.5.0/24 to be active.
  D. The next-hop 172.16.1.2 must be active in route table inet.3 for the route 192.168.5.0/24 to be active.
  B. The next-hop 172.16.1.2 must be part of an active route in route table inet.0 for route 192.168.5.0/24 to be active.

• Question 113:

  Which two Layer 2 protocols are supported on MX Series devices? (Choose two.)

  A. BGP
  B. RIP
  C. RSTP
  D. MSTP
  C. RSTP
  D. MSTP

• Question 114:

  Click the Exhibit button.

  

  Referring to the exhibit, which route preference will be assigned to the route 172.24.0.0/20?

  A. 150
  B. 170
  C. 130
  D. 100
  C. 130

• Question 115:

  You have recently implemented a graceful Routing-Engine switchover (GRES) and want to further reduce down time if a Routing Engine (RE) failure occurs. Which two features can be configured on this device to reduce its downtime in this situation? (Choose two)

  A. VRRP
  B. GR
  C. BFD
  D. NSR
  B. GR
  D. NSR

• Question 116:

  Click the Exhibit button

  

  An operator is unable to establish any IS-IS adjacencies on a router in the network.

  Based on the configuration shown in the exhibit, what is the problem?

  A. Interface loO must be configured in the IS-IS hierarchy
  B. Each network interface needs a unique family ISO address
  C. The IS-IS level for an each interface must be specified
  D. The ISO address for interface loO is not in hex format
  A. Interface loO must be configured in the IS-IS hierarchy

• Question 117:

  What are two valid IPv6 addresses? (Choose two.)

  A. 2bfc::02 :0:0:fe c:5c
  B. 2bfc::2 ::fe c:5c
  C. 2bfc:2 :0:0:fe c:5c
  D. 2bfc:0:0:2 ::fe c:5c
  A. 2bfc::02 :0:0:fe c:5c
  D. 2bfc:0:0:2 ::fe c:5c

• Question 118:

  A customer pays for the bandwidth on a per-packet basis. The network administrator wants to constrain costs and prevent Layer 2 loops on a multihomed Layer 2 WAN network. Which technology would satisfy these requirements?

  A. Rapid Spanning Tree Protocol
  B. Multiple Spanning Tree Protocol
  C. Loop protection
  D. MPLS over GRE
  C. Loop protection

• Question 119:

  Which fields are added to an Ethernet frame when using Q-in-Q?

  A. S-VLAN and C-VLAN
  B. S-VLAN and D-VLAN
  C. P-VLAN and D-VLAN
  D. P-VLAN and C-VLAN
  A. S-VLAN and C-VLAN

• Question 120:

  Your OSPF network is currently operating with a single backbone area and you are concerned with the scalability of your design. Which network design is a best practice for providing the scalability you desire?

  A. Eliminate all designated routers
  B. Implement areas in your network
  C. Reduce the database refresh timer value
  D. Allow each device to perform ASBR duties
  B. Implement areas in your network