Huawei H12-211 Online Practice Questions and Exam Preparation

Huawei H12-211 Online Questions & Answers

• Question 61:

  Refer to the configuration results of the following output, the correct one in the RIP description is ().

  

  A. Automatic summary is on
  B. RIP process number is 1
  C. The interval for sending RIP route update packets is 30s.
  D. The garbage timeout time of the RIP route is 180s.
  C. The interval for sending RIP route update packets is 30s.

• Question 62:

  Which of the following statements are true about ACL deployment on Huawei devices? (Choose all that apply)

  A. ACL can only be used in the outbound direction of an interface
  B. The same ACL can be used on multiple interfaces
  C. The ACL rules can only be configured in the following sequence: 10, 20, 30...
  D. ACLs cannot be used to filter OSPF traffic because OSPF does not use UDP to encapsulate packets
  E. ACLs can be used to match with the TCP/UDP port IDs of packets and to designate the port ID range
  B. The same ACL can be used on multiple interfaces
  E. ACLs can be used to match with the TCP/UDP port IDs of packets and to designate the port ID range

• Question 63:

  As shown in the figure, the R0 and RTB G0/0/1 interfaces are configured with IPV6 addresses of different network prefixes, and the network administrator is on two routers. Both run the OSPFv3 protocol and configure the OSPFv3 Router ID for each router. The correct description is (). (many selected)

  

  A. RTA and RTB can establish OSPFv3 neighbor relationships.
  B. RTA and RTB cannot establish OSPFv3 neighbor relationships.
  C. RTA can ping RTB
  D. RTA cannot ping RTB
  A. RTA and RTB can establish OSPFv3 neighbor relationships.
  C. RTA can ping RTB

• Question 64:

  As shown in the figure, RIP runs between R1 and R2, and R1 cannot learn the route of 2.2.2.2/32 or 2.0.0.0/8.

  

  A. Correct
  B. Error
  A. Correct

• Question 65:

  Which of the following steps are necessary to configure OSPF on a Huawei router? (Choose three)

  A. Configuration of a router ID
  B. Enabling of an OSPF process
  C. Specifying an OSPF area
  D. Configuration of the network segments within each area
  B. Enabling of an OSPF process
  C. Specifying an OSPF area
  D. Configuration of the network segments within each area

• Question 66:

  Which authentication modes does AAA support? (Choose three).

  A. None
  B. Local
  C. Radius
  D. 802.1X
  A. None
  B. Local
  C. Radius

• Question 67:

  After a device is reset, an interface card is hot swapped, or an interface card is reset, the saved MAC address entries on the device or interface card are not lost.

  A. True
  B. False
  B. False

• Question 68:

  After the host obtains the IP address from DHCP server A and restarts, what kind of message will the following message be sent to DHCP server A?

  A. DHCP DISCOVER
  B. DHCP REQUEST
  C. DHCP OFFER
  D. DHCP ACK
  B. DHCP REQUEST

• Question 69:

  Which of the following is not included in the routing table?

  A. Source address
  B. Next hop
  C. Target network
  D. Routing cost
  A. Source address

• Question 70:

  From the perspective of project cutover, there is no need to back up or adjust the configuration file when upgrading the VRP system, because the lost files can be retrieved in the recycle bin.

  A. Yes
  B. Wrong
  B. Wrong