Huawei H12-211 Online Practice Questions and Exam Preparation

Huawei H12-211 Online Questions & Answers

• Question 41:

  Refer to the graphic. Packet encapsulation in the IPsec architecture is performed as shown. Which IPsec mode is being used to encapsulate the packet?

  A. normal mode
  B. transport mode
  C. tunnel mode
  D. this encapsulation is wrong
  C. tunnel mode

• Question 42:

  Refer to the graphic.

  

  The routing table includes direct routes and static routes and the preference of the direct routes cannot be changed.

  A. True
  B. False
  A. True

• Question 43:

  After the administrator successfully logs in to the router through Telnet and finds that the IP address of the interface of the router cannot be configured, the possible causes are ().

  A. The Telnet terminal software used by the administrator prohibits the corresponding operation.
  B. The authentication mode of the Telnet user is incorrectly configured.
  C. The Telnet user level is incorrectly configured.
  D. SNMP parameter configuration error
  C. The Telnet user level is incorrectly configured.

• Question 44:

  In a small network suppporting IPv6, a network administrator wishes implement RIPng. Which of the following commands should be used to enable this protocol?

  A. [RTA-GigabitEthernet0/0/0]ripng 1 enable
  B. [RTA]ripng 1 enable
  C. ripng 1 enable
  D. [RTA-ripng-1]ripng 1 enable
  A. [RTA-GigabitEthernet0/0/0]ripng 1 enable

• Question 45:

  system-view [Huawei]history-command max-size 20

  Refer to the command output. Which statements regarding the shown command are true? (Choose two)

  A. The command is used to adjust the size of the history command buffer
  B. The default value of the history command buffer is 5.
  C. The command should be configured in the user-interface view.
  D. Once configured, commands totalling up to 20 bytes can be saved in the buffer.
  A. The command is used to adjust the size of the history command buffer
  C. The command should be configured in the user-interface view.

• Question 46:

  On the VRP platform, if you want the ping program to use the specified IP address as the source address of the echo request message, which of the following can be used? One parameter?

  A. -a
  B. -s
  C. -d
  D. -n
  A. -a

• Question 47:

  As shown in the broadcast network, OSPF runs on four routers and is in the same area and on the same network segment. OSPF A DR and multiple BDRs will be automatically elected to achieve better backup results.

  

  A. Yes
  B. Wrong
  B. Wrong

• Question 48:

  What is the meaning of 200 in the command "fr map ip 10.1.1.2 200"?

  A. remote logical channel ID
  B. local DLCI
  C. remote interface ID
  D. remote node ID
  B. local DLCI

• Question 49:

  On VRP platform, the command lines are classified into four levels in increasing priority: Visit level, Monitoring level, Configuration level, and Management level. At which level, the operator is permitted to configure service but is not permitted to operate the file system?

  A. Visit level
  B. Monitoring level
  C. Configuration level
  D. Management level
  C. Configuration level

• Question 50:

  Which of the following statements regarding Designated Routers in OSPF are correct? (Choose three)

  A. DR is elected by all the routers in the same network segment.
  B. If the priorities of two routers are different, the router with the lower priority will be elected as DR.
  C. If the priorities of two routers are equal, the router with the higher Router ID will be elected as DR.
  D. DR and BDR must be adjacent.
  A. DR is elected by all the routers in the same network segment.
  C. If the priorities of two routers are equal, the router with the higher Router ID will be elected as DR.
  D. DR and BDR must be adjacent.