Cisco 351-080 Online Practice Questions and Exam Preparation

Cisco 351-080 Online Questions & Answers

• Question 181:

  Which two products provide the ability to create eight VDCs? (Choose two.)

  A. Cisco Nexus 7000 Supervisor 2 Module
  B. Cisco Nexus 7000 Supervisor 1 Module
  C. Cisco Nexus 7700 Supervisor 1 Module
  D. Cisco Nexus 7700 Supervisor 2E Module
  E. Cisco Nexus 7000 Supervisor 2E Module
  D. Cisco Nexus 7700 Supervisor 2E Module
  E. Cisco Nexus 7000 Supervisor 2E Module

• Question 182:

  Refer to the exhibit.

  

  What is the most likely reason for the output that is shown in bold in the exhibit?

  A. One or more of the VLANs that are assigned to the vNIC have been deleted from Cisco UCS Manager.
  B. One or more of the VLANs that are assigned to the vNIC are assigned to different disjoint Layer 2 uplinks.
  C. There are no Ethernet uplinks that are enabled.
  D. The host to which the vNIC belongs is currently powered off.
  E. The vNIC is currently active and uses the fabric failover peer vNIC.
  B. One or more of the VLANs that are assigned to the vNIC are assigned to different disjoint Layer 2 uplinks.

• Question 183:

  Which two statements about dynamic port binding are true? (Choose two.)

  A. The port is connected when the VM is powered on and disconnected when the VM is powered off.
  B. The port is created when the VM is powered on and destroyed when the VM is powered off.
  C. The max-port limits are enforced.
  D. The max-port limits are not enforced.
  E. The port is always connected.
  A. The port is connected when the VM is powered on and disconnected when the VM is powered off.
  C. The max-port limits are enforced.

• Question 184:

  On the Cisco Nexus 7000 Series Switch, Control Plane Policing is enforced on which component?

  A. The supervisor module enforces CoPP before out-of-policy traffic reaches the CPU
  B. The fabric modules enforce CoPP in the fabric before out-of-policy traffic reaches the CPU
  C. The linecards enforce CoPP locally before out-of-policy traffic reaches the CPU
  D. The egress virtual output queue enforces CoPP locally before out-of-policy traffic reaches the CPU
  C. The linecards enforce CoPP locally before out-of-policy traffic reaches the CPU

• Question 185:

  Which protocol message does the Cisco ACE module use to insert or withdraw all RHI routes?

  A. ICMP
  B. SCP
  C. IPv4
  D. SCTP
  B. SCP

• Question 186:

  Regarding disk scrub, which two of these occur to the data on any local drives upon disassociation? (Choose two.)

  A. If disk scrub is enabled, all BIOS settings for the server are erased.
  B. If disk scrub is enabled, all the data access on any local drives is destroyed.
  C. If disk scrub is enabled, the LSI active RAID is destroyed but data is still preserved.
  D. If disk scrub is disabled, all data on any local drives is preserved, including the local storage configuration.
  E. If disk scrub is enabled, all data on any local drives is preserved, including the local storage configuration.
  B. If disk scrub is enabled, all the data access on any local drives is destroyed.
  D. If disk scrub is disabled, all data on any local drives is preserved, including the local storage configuration.

• Question 187:

  A virtual port channel (vPC) allows links that are physically connected to two different Cisco Nexus devices to appear as a single port channel to a third device.

  Which are the mandatory steps for configuring vPC? (Choose six.)

  A. Enable feature vPC
  B. Define domains
  C. Establish peer keepalive connectivity
  D. Create a peer link
  E. Configure the peer link as a trunk port
  F. Create port channels and vPCs
  G. Define port channel load-balancing method
  H. Make sure configurations are consistent
  A. Enable feature vPC
  B. Define domains
  C. Establish peer keepalive connectivity
  D. Create a peer link
  F. Create port channels and vPCs
  H. Make sure configurations are consistent

• Question 188:

  Refer to the exhibit.

  

  According to the equipment tab in Cisco UCS Manager, which is true?

  A. A is an uplink port, B is a fabric port, C is a server port, D is a backplane port, E is a DCE interface, and F is a vNIC
  B. A is an uplink port, B is a server port, C is a fabric port, D is a backplane port, E is a DCE interface, and F is a vNIC
  C. A is an uplink port, B is a fabric port, C is a backplane port, D is a server port, E is a DCE interface, and F is a vNIC
  D. A is an uplink port, B is a server port, C is a fabric port, D is a DCE interface, E is a backplane port, and F is a vNIC
  E. A is an fabric port, B is a downlink port, C is an uplink port, D is a server port, E is a VIC interface, and F is a vNIC
  B. A is an uplink port, B is a server port, C is a fabric port, D is a backplane port, E is a DCE interface, and F is a vNIC

• Question 189:

  Which option is the benefit of Cisco ACE solution?

  A. minimum scalability for application delivery
  B. infrastructure simplification
  C. centralized management for all application teams
  D. completely isolated from network thus providing easy management
  B. infrastructure simplification

• Question 190:

  Which two statements about enhanced zoning are true? (Choose two.)

  A. Enhanced zoning is a mode that shows much more detail for the SAN choices when it is viewed in Fabric Manager.
  B. Enhanced zoning cannot be enabled per VSAN. It is a chassis-wide setting.
  C. Enhanced zoning sets the default zone to the same state in all switches.
  D. Enhanced zoning cannot be enabled in an FCoE environment.
  E. Enhanced zoning sends ACA to lock the fabric when the administrator starts a zone change.
  C. Enhanced zoning sets the default zone to the same state in all switches.
  E. Enhanced zoning sends ACA to lock the fabric when the administrator starts a zone change.