Cisco 350-001 Online Practice Questions and Exam Preparation

Cisco 350-001 Online Questions & Answers

• Question 501:

  You are a network technician, study the exhibit carefully. In this EIGRP network, the output of the command show interface for the link between R2 and R5 indicates that the link load varies between 10 and 35. Which K value setting will be used to make sure that this link is not used by EIGRP when the link load reaches 35, but can be used again when the link load drops below 20?

  

  A. Link load is not read in real time, so there is no way to set the K values to make EIGRP choose to use or not use a link based on the link load.
  B. There is not enough information in the question to determine the correct answer.
  C. Use the K5 setting to include load in EIGRP's metric calculations.
  D. Use the K2 setting to include load in EIGRP's metric calculations.
  A. Link load is not read in real time, so there is no way to set the K values to make EIGRP choose to use or not use a link based on the link load.

• Question 502:

  A router is connected to an HDLC circuit via a T1 physical interface. The SLA for this link only allows for a sustained rate of 768 kb/s. Bursts are allowed for up to 30 seconds at up to line rate, with a window Tc of 125 ms. What should the Be and Be setting be when using generic traffic shaping?

  A. Be = 46320000 , Bc = 96000
  B. Be = , 768000 Be = 32000
  C. Be = , 128000 Be = 7680
  D. Be = , 0 Be = 96000
  A. Be = 46320000 , Bc = 96000

• Question 503:

  Refer to the exhibit. How will traffic be split between the routers, assuming that there are many hosts on this subnet?

  

  A. All traffic will be sent to the primary router (10.1.1.100).
  B. Traffic will be split equally between the two routers (10.1.1.100 and 10.1.1.101).
  C. Traffic will be split 25% (10.1.1.101) / 75% (10.1.1.100) between the two routers.
  D. Traffic will be split 75% (10.1.1.101) / 25% (10.1.1.100) between the two routers.
  D. Traffic will be split 75% (10.1.1.101) / 25% (10.1.1.100) between the two routers.

• Question 504:

  Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?

  A. one global STP instance for all VLANs
  B. one STP instance for each VLAN
  C. one STP instance per set of VLANs
  D. one STP instance per set of bridges
  C. one STP instance per set of VLANs

• Question 505:

  In GLBP, which router will answer on client ARP requests?

  A. all active AVF routers as the first response is used by the client
  B. the AVG router, replying with a different AVF MAC address each time
  C. a random AVF router, based on a GLBP seed hash key
  D. only the AVG router that received the ARP request first
  B. the AVG router, replying with a different AVF MAC address each time

• Question 506:

  Your network is suffering from regular outages. After troubleshooting, you learn that the transmit lead of a fiber uplink was damaged.

  Which two features can prevent the same issues in the future? (Choose two.)

  A. root guard
  B. loop guard
  C. BPDU guard
  D. UDLD
  E. BPDU skew detection
  B. loop guard
  D. UDLD

• Question 507:

  Which three combinations are valid PAgP configurations that will set up a channel? (Choose three.)

  A. On-On
  B. On-Auto
  C. Passive-Active
  D. Desirable-Auto
  E. Active-Active
  F. Desirable-Desirable
  A. On-On
  D. Desirable-Auto
  F. Desirable-Desirable

• Question 508:

  A router that acts as an Internet border gateway has multiple upstream connections that are used in a load-sharing setup. The NOC has identified a DDoS attack from a specific source entering its network via interface GigabitEthernet0/1. The NOC wants to block this suspicious traffic on the border router in a scalable way and without major changes to the different interface configurations.

  Which configuration would block the DDoS attack from the known source (194.90.1.5)?

  A. interface GigabitEthernet0/1 ip address 192.168.1.1 255.255.255.252 ip verify unicast source reachable-via any ! ip route 194.90.1.5 255.255.255.255 Null0
  B. interface GigabitEthernet0/1 ip address 192.168.1.1 255.255.255.252 ip verify unicast source reachable-via any ! ip route 194.90.1.5 255.255.255.255 192.168.1.2
  C. interface GigabitEthernet0/1 ip address 192.168.1.1 255.255.255.252 ip verify unicast source reachable-via rx ! ip route 194.90.1.5 255.255.255.255 Null0
  D. interface GigabitEthernet0/1 ip address 192.168.1.1 255.255.255.252 ip verify unicast source reachable-via rx ! ip route 194.90.1.5 255.255.255.255 192.168.1.2
  A. interface GigabitEthernet0/1 ip address 192.168.1.1 255.255.255.252 ip verify unicast source reachable-via any ! ip route 194.90.1.5 255.255.255.255 Null0

• Question 509:

  Refer to the exhibit. What is the overall type of queuing being used on the outgoing data for interface Ethernet0/1?

  

  A. LLQ
  B. FIFO
  C. CBWFQ
  D. priority queuing
  E. weighted fair queuing
  A. LLQ

• Question 510:

  How the IGMP is queried router elected on a subnet?

  A. based on the highest IP address
  B. based on the lowest IP address
  C. based on the highest configured priority
  D. based on the lowest MAC address
  B. based on the lowest IP address