Cisco 350-001 Online Practice Questions and Exam Preparation

Cisco 350-001 Online Questions & Answers

• Question 211:

  Which two statements are true about the role of split horizon? (Choose two.)

  A. It is a function used by routing protocols to install routes into routing table
  B. It is a function that prevents the advertising of routes over an interface that the router is using to reach a route
  C. Its function is to help avoid routing loops.
  D. It is a redistribution technique used by routing protocols
  B. It is a function that prevents the advertising of routes over an interface that the router is using to reach a route
  C. Its function is to help avoid routing loops.

• Question 212:

  Which statement is correct about IPv6 RA guard?

  A. In host mode, all RA and router redirect messages are allowed on the port.
  B. The RA guard feature is supported only in the egress direction; it is not supported in the ingress direction.
  C. The RA guard feature is not supported on auxiliary VLANs and private VLANs.
  D. The RA guard feature compares configuration information on the Layer 2 device with the information in the received RA frame.
  D. The RA guard feature compares configuration information on the Layer 2 device with the information in the received RA frame.

• Question 213:

  Refer to the exhibit. Which switching feature is being tested?

  

  A. loop guard
  B. PortFast
  C. root guard
  D. BDPU guard
  A. loop guard

• Question 214:

  What is the first thing that happens when IPv6 is enabled on an interface on a host?

  A. A router solicitation is sent on that interface.
  B. There is a duplicate address detection on the host interface.
  C. The link local address is assigned on the host interface.
  D. A neighbor redirect message is sent on the host interface.
  B. There is a duplicate address detection on the host interface.

• Question 215:

  Which two commands are required to enable multicast on a router, knowing that the receivers only support IGMPv2? (Choose two.)

  A. ip pim rp-address
  B. ip pim ssm
  C. ip pim sparse-mode
  D. ip pim passive
  A. ip pim rp-address
  C. ip pim sparse-mode

• Question 216:

  You work as a network engineer for the company, you want to configure two BGP speakers to form an EBGP session across a firewall. On the engineer's network, the firewall always permits TCP sessions that are initiated from the inside network (the network attached to the inside interface of the firewall).

  What prerequisite is there for enabling BGP to run on this network?

  A. EBGP multihop will need to be configured for this to work.
  B. This should work with normal BGP peering, with no additional configuration on the BGP speakers or the firewall.
  C. The BGP protocol port must be opened on the firewall.
  D. There is no way to make BGP work across a firewall.
  A. EBGP multihop will need to be configured for this to work.

• Question 217:

  Drag the actions on the left to the correct order on the right when doing inside to outside NAT translation.

  Select and Place:

  

  

• Question 218:

  Spanning Tree Protocol calculates path cost based on which of these?

  A. interface bandwidth
  B. interface delay
  C. interface bandwidth and delay
  D. hop count
  E. bridge priority
  A. interface bandwidth

• Question 219:

  Which four of these commands are required when implementing DMVPN? (Choose four.)

  A. crypto isakmp policy
  B. crypto ipsec transform
  C. crypto ipsec profile
  D. gre tunnel interface
  E. crypto acl
  F. easy vpn
  A. crypto isakmp policy
  B. crypto ipsec transform
  C. crypto ipsec profile
  D. gre tunnel interface

• Question 220:

  Which mechanism does OSPFv3 use when the router LSA is too big to be sent out?

  A. It relies on IPv6 to do the fragmenting.
  B. It splits the LS Update packet into smaller packets.
  C. It splits the LSA into smaller router LSA packets.
  D. It produces an error.
  C. It splits the LSA into smaller router LSA packets.