Avaya 3100 Online Practice Questions and Exam Preparation

Avaya 3100 Online Questions & Answers

• Question 11:

  Which component registers SIP Endpoints?

  A. System Manager
  B. Communication Manager
  C. Switch
  D. Session Manager
  D. Session Manager

• Question 12:

  Which command is needed to verify an Enhanced Call Forwarding destination?

  A. Change station xxxx
  B. Status station xxxx
  C. Add station xxxx
  D. Edit station xxxx
  B. Status station xxxx

• Question 13:

  For which purpose is Automatic Alternate Routing (AAR) used?

  A. Calls placed within a company over a public network
  B. Calls placed within a company over a private network
  C. Calls placed from outside a company over a private network
  D. Calls placed from outside a company over a public network
  B. Calls placed within a company over a private network

• Question 14:

  On the add trunk-group x form, what must match the DAC in the Dial Plan Analysis form?

  A. FNPA
  B. TAC
  C. COS
  D. Ext
  D. Ext

• Question 15:

  The station lock feature manually or automatically changes the COR of a station to block outgoing calls recently, extensions at a customer's site have been used for out of hours outgoing calls. IT would like to activate this feature automatically on the telephone on site. To address safety concerns, what do you tell the site manager regarding outgoing emergency calls and incoming or outgoing calls if staff needs to work overtime?

  A. The station lock feature does not block incoming calls and using a code they can make emergency or outgoing calls.
  B. The station lock features does not block outgoing emergency calls and using a code they can receive incoming calls and make outgoing calls.
  C. The station lock feature does not block incoming calls or emergency outgoing calls and the telephone can be unlocked from designated telephone(s) by inputting a code.
  D. The station lock feature does not block incoming calls or emergency outgoing calls and the telephone can be unlocked by inputting a code.
  D. The station lock feature does not block incoming calls or emergency outgoing calls and the telephone can be unlocked by inputting a code.

• Question 16:

  Which two Fields and Settings must be verified on the system-parameters customer- options form when adding 46xx or 96xx type telephones? (Choose two)

  A. Maximum Concurrently Registered IP Stations greater than "0"
  B. Maximum Media Gateway VAL Sources greater than "0"
  C. Maximum Off-PBX Telephones greater than "0"
  D. IP Stations field in "y"
  E. Digital Stations field In "y"
  A. Maximum Concurrently Registered IP Stations greater than "0"
  D. IP Stations field in "y"

• Question 17:

  You are configuring Personal Station Access (PSA) and you configure the Communication Manager with the following settings:

  -

  Set TTI enabled = `Y'

  -

  Set PSA Associated code = `25' and disassociate code `#25'

  -

  Set security code for the station = `1234'

  You activate the station by keying in FAC for PSA, station extension number, `#', the security code of the station, and `#'. However, the station is not activated.

  Which statement describes the issue to be addressed?

  A. You need to set TTI = `n'
  B. You did not enable PSA on the COS of the station.
  C. You should not set the security code in sequential order.
  D. You did not key in the correct activation sequence
  B. You did not enable PSA on the COS of the station.

• Question 18:

  You have to add a new G650 Media Gateway to the system. Which command will perform this I

  A. add cabinet next
  B. add port network next
  C. add media ?gateway next
  D. add G6SO-port next.
  C. add media ?gateway next

• Question 19:

  You are adding ten new IP telephones in a small company administered with a G430 Media Gateway and a S8300D ICC main server. The G430 has the S8300D inserted in the slot V1, and MM71 in the slot V2, and an MM712 in the slot V3. Which hardware module will act as Gatekeeper for the telephones?

  A. MM710
  B. MM712
  C. MGP on the media gateway
  D. S8300D server using Processor Ethernet (PE)
  D. S8300D server using Processor Ethernet (PE)

• Question 20:

  Which two fields and settings must be verified on the system-parameters customer-options form when adding 16xx or 96xx type telephones? (Choose two.)

  A. Maximum Concurrently Registered IP Stations greater than "0"
  B. Maximum Media Gateway VAL Sources greater than "0"
  C. Maximum Off-PBX Telephones greater than "0"
  D. IP Stations field is "y"
  E. Digital Stations field is "y"
  A. Maximum Concurrently Registered IP Stations greater than "0"