Cisco 300-625 Online Practice Questions and Exam Preparation

Cisco 300-625 Online Questions & Answers

• Question 1:

  Which configuration is needed to enable manual ESP mode for Fibre Channel TrustSec on Cisco MDS switches?

  A. MDS(config)# interface fc 1/1 MDS(config-if)# fcsp esp manual
  B. MDS(config)# fcsp esp manual
  C. MDS(config)# interface fc 1/1 MDS(config-if)# fcsp mode gcm MDS(config-if-fcsp)# fcsp esp manual
  D. MDS(config)# interface fc 1/1 MDS(config-if)# fcsp esp manual MDS(config-if-fcsp)# mode gcm
  A. MDS(config)# interface fc 1/1 MDS(config-if)# fcsp esp manual

• Question 2:

  DRAG DROP

  Drag and drop the boot issues from the left onto the correct solutions on the right.

  Select and Place:

  

  

• Question 3:

  A storage network engineer must configure a 48-port Cisco MDS switch to reject any login requests to VSAN 10 from unauthorized Fibre Channel devices and switches. All the devices that were already logged in to the switch from this VSAN must be allowed without any manual configuration. Which configuration must be applied?

  A. switch(config)# feature port-security switch(config)# port-security activate vsan 10
  B. switch(config)# feature port-security switch(config)# port-security activate vsan 10 no auto-learn
  C. switch(config)# feature port-security switch(config)# port-security database vsan 10 switch(config-port-security)# any-wwn interface fc1/1 ?fc1/48
  D. switch(config)# port-security activate vsan 10
  D. switch(config)# port-security activate vsan 10

• Question 4:

  A storage network engineer is implementing a port channel for multiple FCIP interfaces with write acceleration in a client's storage network. Which channel mode must be used?

  A. on
  B. passive
  C. active
  D. force
  C. active

• Question 5:

  Refer to the exhibit.

  

  What is the result of the configuration?

  A. No-drop CoS values are advertised by the DCBX.
  B. LFC is prioritized over PFC on Ethernet 1/10.
  C. PFC operates on Ethernet 1/10 regardless of the capability of the peer.
  D. PFC fails to operate properly unless LFC is disabled on Ethernet 1/10.
  A. No-drop CoS values are advertised by the DCBX.

• Question 6:

  DRAG DROP

  Drag and drop the DCNM configuration tasks from the left onto the correct tools on the right.

  Select and Place:

  

  

• Question 7:

  Refer to the exhibit.

  

  Which command is used to determine which switch has the lock?

  A. show fcs ie vsan
  B. show zoneset active
  C. show zone status
  D. show flogi database
  C. show zone status

• Question 8:

  Refer to the exhibit.

  

  Device alias information must be merged for two fabrics. Which setting must match on both fabrics before the merge can be performed successfully?

  A. device-alias mode
  B. session
  C. qos
  D. smart-zoning
  A. device-alias mode

• Question 9:

  Which two steps are mutual between Cisco secure boot and UEFI secure boot? (Choose two.)

  A. bootloader
  B. operating system
  C. microloader
  D. kemel
  E. hardware anchor
  A. bootloader
  B. operating system

• Question 10:

  A storage network engineer must install and configure a new MDS switch in a data center network. Which two statements about available choices during the MDS switch initial setup are correct? (Choose two.)

  A. The engineer can choose what will be the administrator account.
  B. The secure password standard is required.
  C. The engineer can configure the default zone policy.
  D. The engineer can configure the default switch port trunk mode.
  E. The engineer does not have the choice to enable or disable full zoneset distribution.
  A. The engineer can choose what will be the administrator account.
  C. The engineer can configure the default zone policy.