Cisco 300-370 Online Practice Questions and Exam Preparation

Cisco 300-370 Online Questions & Answers

• Question 81:

  Refer to the exhibit.

  

  Which statement describes how the Band Select feature works on the wireless controller?

  A. The access point uses the load balancing feature to move the clients to 5 Ghz.
  B. The access point changes the DTIM period on the 2.4 Ghz band.
  C. The access point recommends the band in the association response to the client.
  D. The access point ignores and delays the probe request of the client on the 2.4 Ghz.
  C. The access point recommends the band in the association response to the client.

• Question 82:

  A network engineer has identified clients who are experiencing delays while roaming. The network is configured with WPA2-Enterprise, AES encryption, 802.1X authentication, and Cisco Centralized Key Management. Which change resolves the roaming delays?

  A. Utilize a supplicant that supports Cisco Centralized Key Management.
  B. Enable AES and TKIP encryption.
  C. Disable client session timeout.
  D. Install wireless device drivers from Cisco.
  A. Utilize a supplicant that supports Cisco Centralized Key Management.

• Question 83:

  

  Refer to the exhibit. What is a possible reason why the non-root AP fails to associate to the root AP?

  A. The authentication server failed to respond.
  B. Invalid credentials are entered.
  C. Eap_methods is misconfigured.
  D. An invalid PSK is configured.
  B. Invalid credentials are entered.

• Question 84:

  While reviewing CleanAir data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default severity level has been changed. Which value does the engineer select to reset the severity level to its factory setting?

  A. informational
  B. major
  C. minor
  D. warning
  E. critical
  D. warning

• Question 85:

  Refer to the exhibits. An engineer is troubleshooting connectivity issues on the guest network.

  

  Which cause of the issue is true?

  A. The spanning-tree portfast trunk command must be removed.
  B. The switchport mode must be configured as access.
  C. The interface group has incorrect mappings.
  D. The trunk port does not have the correct VLANs allowed.
  D. The trunk port does not have the correct VLANs allowed.

• Question 86:

  An engineer is troubleshooting AP join issues on a wireless infrastructure. While gathering debugs, the engineer notices that one of the commands may generate an excessive amount of data on the console. Which command causes this to occur?

  A. debug capwap detail enable
  B. debug capwap errors enable
  C. debug capwap info enable
  D. debug capwap events enable
  E. debug capwap packet enable
  F. debug capwap payload enable
  B. debug capwap errors enable

• Question 87:

  In a high-density deployment on a customer site with ID 339696181, how do you mitigate the cell size in a large coverage area?

  A. Disable ClientLink on the WLC.
  B. Set a high supported data rate.
  C. Increase the power of the AP.
  D. Set a high mandatory
  C. Increase the power of the AP.

• Question 88:

  

  Refer to the exhibit. When you analyze the spectrum, you find some interference from a non-802.11 device. Which device is causing the interference based on the spectrum capture?

  A. Bluetooth
  B. DECT phone
  C. video camera
  D. microwave oven
  B. DECT phone

• Question 89:

  Refer to the exhibit.

  

  Which two statements about the PoE are true? (Choose two.)

  A. This configuration typically is used for data-only interface.
  B. This setting is recommended for a PoE interface.
  C. The interface detects and supplies power automatically.
  D. Power is preallocated to the interface, even when no device is connected.
  E. The interface will never supply power.
  A. This configuration typically is used for data-only interface.
  E. The interface will never supply power.

• Question 90:

  From the WLC GUI, which RRM setting do you configure to avoid non-Wi-Fi interference?

  A. Coverage
  B. TPC
  C. General
  D. DCA
  D. DCA