Cisco 200-301 Online Practice Questions and Exam Preparation

Cisco 200-301 Online Questions & Answers

• Question 1521:

  Which WLC management connection type is vulnerable to man-in-the-middle attacks?

  A. SSH
  B. HTTPS
  C. Telnet
  D. console
  C. Telnet

  ---

  No encryption would mean more chance of eavesdropping on the connection.

  Telnet sends all data in plain text, allowing for a man in the middle attack to gain access to the data sent, including login credentials.

• Question 1522:

  What is a function of a Layer 3 switch?

  A. move frames between endpoints limited to IP addresses
  B. transmit broadcast traffic when operating in Layer 3 mode exclusively
  C. forward Ethernet frames between VLANs using only MAC addresses
  D. flood broadcast traffic within a VLAN
  A. move frames between endpoints limited to IP addresses

• Question 1523:

  What is the maximum bandwidth of a T1 point-to-point connection?

  A. 1.544 Mbps
  B. 2.048 Mbps
  C. 34.368 Mbps
  D. 43.7 Mbps
  A. 1.544 Mbps

  ---

  What Does Point-to-Point T1 Mean? Point-to-point T1 is a direct and/or a private T1 network connection between two or more networks or locations. It is a secure, private and unshared network connection that provides a T1 network at a speed of 1.544 mbps between multiple networks/locations.

• Question 1524:

  Refer to the exhibit.

  

  PC A is communicating with another device at IP address 10.227.225.255. Through which router does router Y route the traffic?

  A. router A
  B. router B
  C. router C
  D. router D
  D. router D

  ---

  Look for the longest match in the routing table.

• Question 1525:

  A project objective is to minimize the association time to the different access points as mobile devices move around the office. The ideal solution must cover numerous devices and device types, including laptops, mobile phones, tablets and wireless printers. What must be configured?

  A. 802.11v BSS Max Idle Service
  B. 802.11v Disassociation Imminent
  C. 802.11ax BSS configure
  D. 802.11k neighbor List Dual Band
  B. 802.11v Disassociation Imminent

  ---

  802.11v

  Basic Service Set (BSS) transition management - BSS transition management with Disassociation Imminent allows the network's control layer to influence client roaming behavior by providing it the load information of nearby access points.

  The device takes this information into account when deciding among the possible roam targets.

  Directed Multicast Service (DMS) - DMS optimizes multicast traffic transmission on wireless networks. The device uses this information to enhance multicast communication and preserve device battery life. BSS Max Idle Service - The BSS Max Idle Service helps clients and access points efficiently decide how long to remain associated when no traffic is being transmitted. The device uses this information to preserve device battery life. Disassociation Imminent - The Disassociation Imminent option sets a flag

  in 11v request telling the client that it needs to roam, or it will be disassociated after a certain amount of time.

  https://support.accessagility.com/hc/802.11k-802.11r-and-802.11v

• Question 1526:

  DRAG DROP

  Drag and drop the Rapid PVST+ forwarding state actions from the left to the right. Not all actions are used.

  Select and Place:

  

  

• Question 1527:

  Which wireless security method uses Simultaneous Authentication of Equals (SAE)?

  A. WPA2-Personal
  B. WPA3-Personal
  C. WEP
  D. WPA2-Enterprise
  B. WPA3-Personal

  ---

  WPA3-Personal replaces the pre-shared key (PSK) mechanism with SAE, which provides stronger protection against offline dictionary attacks and improves security during the initial authentication process between clients and access points.

• Question 1528:

  What are two disadvantages of a full-mesh topology? (Choose two.)

  A. It requires complex configuration.
  B. It needs a high MTU between sites.
  C. It works only with BGP between sites.
  D. It has a high implementation cost.
  E. It must have point-to-point communication.
  A. It requires complex configuration.
  D. It has a high implementation cost.

• Question 1529:

  Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two.)

  A. interface GigabitEthernet0/0/1 channel-group 10 mode auto
  B. interface GigabitEthernet0/0/1 channel-group 10 mode on
  C. interface port-channel 10 no switchport ip address 172.16.0.1 255.255.255.0
  D. interface GigabitEthernet0/0/1 channel-group 10 mode active
  E. interface port-channel 10 switchport switchport mode trunk
  C. interface port-channel 10 no switchport ip address 172.16.0.1 255.255.255.0
  D. interface GigabitEthernet0/0/1 channel-group 10 mode active

  ---

  https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/16-/configuration_guide/b_166_lyr2_lyr3_9500_cg/b_166_lyr2_lyr3_9500_cg_chapter_011.html#concept_A56CA70C47CD4E6D9381082E649FDA7A

• Question 1530:

  Aside from discarding, which two states does the switch port transition through while using RSTP (802.1w)? (Choose two)

  A. listening
  B. blocking
  C. forwarding
  D. learning
  E. speaking
  C. forwarding
  D. learning

  ---

  RSTP goes from Discarding, Learning, and Forwarding

  https://www.cisco.com/c/en/us/support/docs/lan-switching/spanning-tree-protocol/24062-146.html