Cisco 200-150 Online Practice Questions and Exam Preparation

Cisco 200-150 Online Questions & Answers

• Question 281:

  Drag and drop the CLI configuration command on the left to the correct order on the right to configure a Layer 3 interface. Not all options are used.

  Select and Place:

  

  

• Question 282:

  In block-level storage, SCSI commands are transmitted between which two devices? (Choose two.)

  A. master controller
  B. NAS head unit
  C. target
  D. initiator
  E. spine switch
  C. target
  D. initiator

• Question 283:

  Which description of a multiple-initiator target zone is true?

  A. It uses more TCAM than a single-initiator single target zone.
  B. It increases the number of zones.
  C. It uses less TCM space than a single-initiator target zone.
  D. It blocks RSCNs between initiators.
  A. It uses more TCAM than a single-initiator single target zone.

• Question 284:

  The MAC address table on a Cisco Nexus Series switch is full What Layer 2 network behavior will occur while the network MAC address table remains full?

  A. The switch will remove all dynamically learned MAC addresses from the table
  B. Frames with an unknown destination address will be flooded
  C. All frames will be flooded
  D. The switch will reset the MAC address table, removing all MAC addresses.
  B. Frames with an unknown destination address will be flooded

• Question 285:

  How does a GLBP cluster respond to a host ARP request for the virtual IP address?

  A. The highest priority AVF responds by using its own hardware MAC address.
  B. The least utilized router responds by using its own virtual MAC address.
  C. The AVG responds by using one virtual MAC address.
  D. The AVG responds by using its own hardware MAC address.
  A. The highest priority AVF responds by using its own hardware MAC address.

• Question 286:

  Refer to the exhibit.

  

  What is the result when you run the command?

  A. All switches in the fabric receive the active zone set.
  B. The zone set is activated on the switch only.
  C. On the reboot, all switches in the fabric receives the active zone set.
  D. The default zone set is activated on all switches in the fabric.
  A. All switches in the fabric receive the active zone set.

• Question 287:

  Refer to the exhibit.

  

  Which protocol is used to map an IP address by broadcasting a request to the LAN?

  A. ARP
  B. gratuitous ARP
  C. RARP
  D. proxy ARP
  A. ARP

• Question 288:

  In which layer of the OSI model are TCP port numbers defined?

  A. session
  B. network
  C. data-link
  D. transport
  D. transport

• Question 289:

  Which statement is true regarding endpoint registration authentication?

  A. When a Subzone is a set for ''Treat as Authenticated''. the endpoint is require to have the correct authentications configured.
  B. Expressways and Endpoint do not need to be synchronized with identical NTP timestamps
  C. SIP endpoints always need authentication credentials.
  D. Authentication credentials can be stored in the database of the Expressway.
  D. Authentication credentials can be stored in the database of the Expressway.

• Question 290:

  Which is a protocol used in the traversing of media across a firewall through the Expressway?

  A. SIP
  B. H.460.18/19
  C. H239
  D. H.245
  B. H.460.18/19