Cisco 200-150 Online Practice Questions and Exam Preparation

Cisco 200-150 Online Questions & Answers

• Question 1:

  How many Fibre Channel zone sets can be active at one time for any given VSAN?

  A. 1
  B. 2
  C. 3
  D. 4
  A. 1

• Question 2:

  On a Cisco Nexus switch, you need to configure an ACL that denies only SSH traffic from any source to host 10 68 68 68 Which command should you use?

  A. switch(config)# ip access-list test switch(config-acl)# deny tcp any host 10.68.68.68 eq 22
  B. switch(config)# access-list 101 deny tcp any host 10.68.68.68 eq 22
  C. switch(config)# access-list 101 deny tcp any host 10.168.68.68 eq 22 switch(config)# access-list 101 permit ip any any
  D. switch(config)# ip access-list test switch(config-acl)# deny tcp any host 10.68.68.68 eq 22 swrtch(config-acl)# permit ip any any
  C. switch(config)# access-list 101 deny tcp any host 10.168.68.68 eq 22 switch(config)# access-list 101 permit ip any any

• Question 3:

  Which two characteristics of IPv6 link local addresses are true? (Choose two.)

  A. multicast
  B. Forwarding scope is site local only
  C. unicast
  D. They must always start with FE80 1000 0000 0000
  E. Forwarding scope is link local only.
  D. They must always start with FE80 1000 0000 0000
  E. Forwarding scope is link local only.

• Question 4:

  Refer to the exhibit.

  

  Which statement about the output from SW2 is true?

  A. SW2 discovers SW1 as an LLDP neighbor on port Ethl/1.
  B. SW1 discovers SW2 as an LLDP neighbor on port Eth1/1.
  C. SW2 discovers SW1 as an LLDP neighbor on port Eth1/2
  A. SW2 discovers SW1 as an LLDP neighbor on port Ethl/1.

• Question 5:

  In Fibre Channel networking, the FCID is composed of which set of identifiers?

  A. VSAN ID. zone ID, port ID
  B. VSAN ID. area ID. port ID
  C. domain ID. zone ID. port ID
  D. domain ID, area ID. port ID
  D. domain ID, area ID. port ID

• Question 6:

  Which description of a multiple-initiator single-target zone is true?

  A. It uses less TCAM space than a single-initiator single-target zone
  B. lt blocks RSCNs between initiators.
  C. It increases the number of zones
  D. It uses more TCAM space than a single-initiator single-target zone
  B. lt blocks RSCNs between initiators.

• Question 7:

  Which two actions can access lists be used for? (Choose two)

  A. preempting VIPs on HSRP selectively
  B. triggering routing updates
  C. matching packets in QoS policies
  D. restricting remote access to a switch
  E. authenticating users
  C. matching packets in QoS policies
  D. restricting remote access to a switch

• Question 8:

  Which two benefits of a single-initiator single-target zone are true? (Choose two.)

  A. It reduces the number of required zones
  B. It scales efficiently to multiple targets
  C. lt allows RSCNs between initiators
  D. It provides increased security
  E. It conserves TCAM resources
  A. It reduces the number of required zones
  C. lt allows RSCNs between initiators

• Question 9:

  Which two descriptions of the WWNNs on a server that has two physical HBAs are true? (Choose two.)

  A. Each WWNN is globally unique
  B. There are four WWNNs
  C. Each WWNN is locally unique
  D. All WWNNs are identical
  E. There are two WWNNs.
  B. There are four WWNNs
  C. Each WWNN is locally unique

• Question 10:

  A switch receives a frame The destination MAC address is located on the same port where the switch received the frame Which action does the switch perform on the frame?

  A. buffer
  B. filter
  C. forward
  D. flood
  B. filter