Cisco 200-150 Online Practice Questions and Exam Preparation

Cisco 200-150 Online Questions & Answers

• Question 261:

  Which type of cable do you use with a Cisco QSFP 40-Gbps BiDi transceiver?

  A. MMF
  B. active twinax
  C. STP
  D. SMF
  A. MMF

  ---

  Reference: https://www.cisco.com/c/en/us/products/collateral/interfaces-modules/transceiver-modules/data_sheet_c78-660083.html

• Question 262:

  Instructions:

  THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.

  To access the multiple- choice questions, click on the numbered boxes on the left of the top panel.

  There are four multiple- choice questions with this task. Be sure to answer all four questions before selecting the Next button.

  Scenario:

  Customer is configuring FCoE and NPV in their Data Center on Cisco Nexus 5000 Series Switches. Please go through the Topology and Exhibit 1 through 4 to answer the questions.

  Topology:

  

  Exhibit 1.

  

  Exhibit 2.

  

  Exhibit 3.

  

  Exhibit 4.

  

  Which statement regarding Cisco Nexus 5000 Series switches is true?

  A. Cisco Nexus 5000 Series switches operate in r routing mode.
  B. Cisco Nexus 5000 Series switches operate in FCoE mode.
  C. Cisco Nexus 5000 Series switches operate in fabric mode.
  D. Cisco Nexus 5000 Series switches operate in NPV mode.
  C. Cisco Nexus 5000 Series switches operate in fabric mode.

• Question 263:

  Which route type is the most trustworthy for a Cisco routing device?

  A. OSPF dynamic
  B. EIGRP dynamic
  C. static
  D. BGP dynamic
  C. static

• Question 264:

  A network engineer needs to configure an SVI on a Cisco Nexus Series switch After configuring VLAN 10, which set of commands must the engineer enter, to complete the SVI configuration?

  

  A. Option A
  B. Option B
  C. Option C
  D. Option D
  D. Option D

• Question 265:

  Which two types of endpoints are used for the Ethernet encapsulation of Fibre Channel frames? (Choose two.)

  A. FCoE node (ENode)
  B. Fiber Channel Forwarder (FCF)
  C. FIP
  D. Virtual Fibre Channel
  E. iSCSI
  A. FCoE node (ENode)
  B. Fiber Channel Forwarder (FCF)

• Question 266:

  Which two protocols are associated with the link layer of the OSI reference model? (Choose two)

  A. VTP
  B. SSH
  C. CDP
  D. BGP
  E. DNS
  A. VTP
  C. CDP

• Question 267:

  Which block storage protocol can be used over an unlimited distance?

  A. SMB
  B. FCoE
  C. Fibre Channel
  D. iSCSI
  D. iSCSI

  ---

  Reference: https://www.digiliant.com/what-s-iscsi-pid-26.html

• Question 268:

  Which two descriptions of Fibre WWNs are true? (Choose two.)

  A. 48bits long
  B. 64 or 128 bits long
  C. 96 bits long
  D. manually configured on each device by an administrator
  E. allocated to manufactures by IEEE
  B. 64 or 128 bits long
  E. allocated to manufactures by IEEE

• Question 269:

  Which situation will cause a switch to flood traffic out all of the ports on the switch?

  A. The switch receives a destination MAC address of 0000.0000.0000
  B. The switch receives a destination MAC address of ffff.ffff.ffff
  C. The switch receives a source MAC address of 0000.0000.0000
  D. The switch's TCAM reaches the MAC address limit.
  E. The switch was configured in cut-through mode.
  B. The switch receives a destination MAC address of ffff.ffff.ffff

• Question 270:

  Which two protocols can you use for SAN storage that is accessed via low-latency, high-bandwidth networking'? (Choose two )

  A. iSCSI
  B. CIFS
  C. AFP
  D. FCP
  E. NFS
  A. iSCSI
  D. FCP