Cisco 200-105 Online Practice Questions and Exam Preparation

Cisco 200-105 Online Questions & Answers

• Question 271:

  What about HSRP IP Address is true?

  A. If it's part of the LAN
  B. Part of all other networks
  C. Local to the interface
  D. Appears in the routing table
  E. Acts as default route for that interface
  E. Acts as default route for that interface

• Question 272:

  Which Cisco platform can verify ACLs?

  A. Cisco Prime Infrastructure
  B. Cisco Wireless LAN Controller
  C. Cisco APIC-EM
  D. Cisco IOS-XE
  A. Cisco Prime Infrastructure

• Question 273:

  When you enable PortFast on a switch port, the port immediately transitions to which state?

  A. Blocking
  B. Forwarding
  C. Learning
  D. Listening
  B. Forwarding

• Question 274:

  Which command displays the CHAP authentication process as it occurs between two routers?

  A. debug chap authentication
  B. debug authentication
  C. debug chap ppp
  D. debug ppp authentication
  D. debug ppp authentication

• Question 275:

  DRAG DROP

  Drag and drop the STP features from the left onto the correct descriptions on the right.

  Select and Place:

  

  

• Question 276:

  Which statement about VLAN configuration is true?

  A. The switch must be in config-vlan mode before you configure an extended VLAN.
  B. Dynamic inter-VLAN routing is supported on VLAN 2 through VLAN 4064.
  C. A switch in VTP transparent mode saves the VLAN database to the running configuration only.
  D. The switch must be in VTP server or transparent mode before you configure a VLAN.
  D. The switch must be in VTP server or transparent mode before you configure a VLAN.

• Question 277:

  Which VTP operating mode enables a switch to forward VTP information while ignoring synchronization?

  A. off
  B. server
  C. transparent
  D. client
  C. transparent

• Question 278:

  Which command do you enter to verify an SVI?

  A. show running-configuration | include vlan5
  B. show vlan5
  C. show interface vlan5
  D. show startup-configuration | include vlan5
  C. show interface vlan5

• Question 279:

  Which command can you enter to verify the status and ports of a specific VLAN?

  A. show interfaces trunk
  B. show vlan brief
  C. show vlan id
  D. show running-config
  C. show vlan id

• Question 280:

  What is the purpose of LCP?

  A. to perform authentication
  B. to negotiate control options
  C. to encapsulate multiple protocols
  D. to specify asynchronous versus synchronous
  B. to negotiate control options

  ---

  In order to be sufficiently versatile to be portable to a wide variety of environments, PPP provides a Link Control Protocol (LCP). The LCP is used to automatically agree upon the encapsulation format options, handle varying limits on sizes of packets, detect a looped-back link and other common misconfiguration errors, and terminate the link. Other optional facilities provided are authentication of the identity of its peer on the link, and determination when a link is functioning properly and when it is failing.

  Reference: http://www.ietf.org/rfc/rfc1661.txt