Juniper JN0-360 Online Practice Questions and Exam Preparation

Juniper JN0-360 Online Questions & Answers

• Question 291:

  What are two ways that nonstop routing works? (Choose two.)

  A. by enabling redundant REs to switch from primary RE to backup RE
  B. by alerting peer nodes of any routing table changes
  C. by enabling redundant REs to run a different version of the Junos OS
  D. by replicating routing protocol information
  A. by enabling redundant REs to switch from primary RE to backup RE
  D. by replicating routing protocol information

• Question 292:

  Which two statements are correct regarding LDP-signaled Layer 2 circuits? (Choose two.)

  A. You must enable the Layer 2 VPN signaling NLRI.
  B. You must configure the virtual circuit identifier.
  C. You must specify the neighbor using the tunnel end-point IP address.
  D. You must define a unique site-identifier value.
  B. You must configure the virtual circuit identifier.
  C. You must specify the neighbor using the tunnel end-point IP address.

• Question 293:

  Which two elements are valid in the BGP path selection algorithm? (Choose two.)

  A. lowest local preference value
  B. lowest multi-exit discriminator
  C. highest multi-exit discriminator
  D. highest local preference value
  B. lowest multi-exit discriminator
  D. highest local preference value

• Question 294:

  What are two valid statements for virtual switches on MX Series devices? (Choose two.)

  A. Integrating routing and bridging (IRB) interfaces are supported.
  B. Layer 2 interfaces are supported.
  C. Interfaces are inherently loop free.
  D. Trunk interfaces are not supported.
  A. Integrating routing and bridging (IRB) interfaces are supported.
  B. Layer 2 interfaces are supported.

• Question 295:

  Which three IPv6 addresses are valid equivalents for the address 2001:0000:0000:0000:0134:fc0e:cc8b:458a? (Choose three?)

  A. 2001:134:fc0e:cc8b:458a
  B. 2001:0:0:0:0134:fc0e:cc8b:458a
  C. 2001:0:0:0134:fc0e:cc8b:458a
  D. 2001::134:fc0e:cc8b:458a
  E. 2001:0::0:134:fc0e:cc8b:458a
  B. 2001:0:0:0:0134:fc0e:cc8b:458a
  D. 2001::134:fc0e:cc8b:458a
  E. 2001:0::0:134:fc0e:cc8b:458a

• Question 296:

  Which statement is correct about OSPF Type 7 LSAs?

  A. They are converted into Type 5 LSAs by the ASBR.
  B. They are converted into Type 5 LSAs by the ABR.
  C. They are converted into Type 3 LSAs by the ABR.
  D. They are converted into Type 4 LSAs by the ABR.
  B. They are converted into Type 5 LSAs by the ABR.

• Question 297:

  In an OSPF environment, which two configuration parameters are used to determine which router is the DR? (Choose two.)

  A. the router with the highest priority
  B. the router with the lowest priority
  C. the router with the highest RID
  D. the router with the lowest RID
  A. the router with the highest priority
  C. the router with the highest RID

• Question 298:

  Which IS-IS adjacencies? (Choose two.)

  A. Level 1 adjacencies can form in the same (intra) area only.
  B. Level 2 adjacencies are formed between (inter) areas only.
  C. Level 2 adjacencies can be established either interarea or intra-area.
  D. Level 2 adjacencies can form within the same (intra) area only.
  A. Level 1 adjacencies can form in the same (intra) area only.
  C. Level 2 adjacencies can be established either interarea or intra-area.

• Question 299:

  Which PDU type is sent by an IS-IS router when it detects that its link-state database is out of date?

  A. hello
  B. link state
  C. complete sequence number
  D. partial sequence number
  D. partial sequence number

• Question 300:

  Click the Exhibit.

  

  Your network consists of subnets shown in the exhibit. You are asked to create an aggregate route for Router 1. What is the appropriate prefix for the aggregate route in this scenario?

  A. 172.42.32.0/20
  B. 172.42.32.0/22
  C. 172.42.32.0/19
  D. 172.42.32.0/21
  C. 172.42.32.0/19