Aruba Certified Switching Professional

A company has recently purchased a ClearPass AAA solution. Their network consists of AOS-CX switches at the access layer. The company is implementing a rollout of IoT devices for smart building management to control the lighting and HVAC systems. The network administrator is concerned about allowing secure access to these devices since they only support MAC-Auth.

Which ClearPass feature should the administrator leverage to help determine that MAC address spoofing is not occurring for this group of devices?

When implementing deficit weighted round robin queuing, what importance does the weight value have?

A network administrator is implementing BGP for a larger network. The network has over 20 exit points across 15 different BGP routers. The administrator does not want to implement a fully-meshed iBGP
peering between all BGP routers.

Which feature should the administrator implement to reduce the number of peers the administrator needs to define?

A network administrator wants to replace older access layer switches with AOS-CX 6300 switches.

Which virtual switching technology can the administrator implement with this solution?

Examine the partial output of the BGP routing table of an AOS-CX switch:

The switch is learning about four possible path to reach the 1.0.0.0/8 network.
Based on this output, which next-hop route will the AOS-CX select to be placed in the IP routing table?

A customer has twenty AOS-CX switches that will be managed by NetEdit and would like support for NetEdit these switches will exist in the network for at least five years.

Which type of licensing should be used by this customer?

Which protocol should be configured to allow NetEdit to discover third-party devices?

Which statement is correct regarding ACLs and TCAM usage?

A network administrator is tasked to set up BGP in the company's network. The administrator is defining an eBGP peering between an AOS-CX switch and a directly-connected service provider. The administrator has configured the following on the AOS-CX switch:

However, when using the "show bgp all summary" command, the state does not display "Established" for the eBGP peer.

What must the administrator configure to fix this issue?

An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and
secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification,
the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.

What would cause this problem?