HP HPE6-A73 Online Practice Questions and Exam Preparation

HP HPE6-A73 Online Questions & Answers

• Question 81:

  What is correct regarding the tunneling of user traffic between AOS-CX switches and Aruba Mobility Controllers (MCs)?

  A. Uses IPSec to protect the management and data traffic
  B. Uses IPSec to protect the management traffic
  C. Supports only port-based tunneling
  D. Uses the same management protocol as Aruba APs
  D. Uses the same management protocol as Aruba APs

• Question 82:

  An administrator wants to implement dynamic segmentation policies. The network consists of AOS-CX and Aruba gateways.

  Which type of forwarding should the administrator implement for users that already connect via wireless, but will also be connecting on Ethernet switch ports?

  A. User-based tunneling (UBT)
  B. Port-based tunneling (PBT)
  C. Switch-to-switch tunneling (SST)
  D. Local switching
  A. User-based tunneling (UBT)

• Question 83:

  Which AOS-CX feature is used to prevent head-on-line (HOL) blocking?

  A. VSF
  B. WFQ
  C. VOQ
  D. VSX
  C. VOQ

• Question 84:

  An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.

  What would cause this problem?

  A. Local optimization was not enabled on the VSX LAG
  B. The VSX LAG hash does not match the remote peer
  C. The VSX LAG interfaces are in layer-3 mode
  D. LACP was enabled in active mode on the VSX LAG
  B. The VSX LAG hash does not match the remote peer

• Question 85:

  What is correct regarding policy-based routing?

  A. Policies can only be applied to routed interfaces.
  B. Policies can be applied inbound and outbound.
  C. Monitoring of policy interfaces occurs every 60 seconds.
  D. Policy actions include routing permitting or dropping traffic.
  A. Policies can only be applied to routed interfaces.

• Question 86:

  Examine the configuration performed on newly deployed AOS-CX switches:

  

  After performing this configuration, the administrator notices that the switch ports always remain in the EAP start state. What should the administrator do to fix this problem?

  A. Define the server group cppm
  B. Set the ports to client-mode
  C. Create and assign a local user role to the ports
  D. Enable change of authorization (CoA)
  A. Define the server group cppm

• Question 87:

  Examine the AOS-CS switch output:

  

  Based on this output, what is correct?

  A. 802.1X authentication was successful, but MAC authentication is yet to start
  B. 802.1X authentication occurred and downloadable user roles are deployed
  C. A local user role was deployed using a ClearPass solution
  D. Only 802.1X authentication is configured on the port
  B. 802.1X authentication occurred and downloadable user roles are deployed

• Question 88:

  A network has two AOS-CX switches connected to two different service providers. The administrator is concerned about bandwidth consumption on the service provider links and learned that the service providers were using the company as a transit AS.

  Which feature should the administrator implement to prevent this situation?

  A. Configure route maps and apply them to BGP
  B. Configure the two switches as route reflectors
  C. Configure a classifier policy to disable MED
  D. Configure bi-directional forwarding detection on both switches
  A. Configure route maps and apply them to BGP

• Question 89:

  What is the purpose of the transit VLAN when implementing dynamic segmentation policies involving AOS-CX switches and an Aruba gateway solution?

  A. It identifies the VLAN that the user traffic will be assigned to when it comes out of the tunnel and is forwarded by the gateway.
  B. It identifies the VLAN that the user traffic will be assigned to, whether the traffic is tunneled or locally switched
  C. It defines the VXLAN identifier to identified UBT traffic between the AOS-CX switches and the gateway solution
  D. It identifies the VLAN that the switch will use when tunneling the traffic to the gateway
  D. It identifies the VLAN that the switch will use when tunneling the traffic to the gateway

• Question 90:

  An administrator wants to implement a virtual switching technology that implements a single control-plane solution. Which S-CX switches would meet these criteria?

  A. All AOS-CX switching platforms
  B. AOS-CX 6300 and 6400 switches
  C. AOS-CX 6300, 6400, and 83xx switches
  D. AOS-CX 6300 switches
  C. AOS-CX 6300, 6400, and 83xx switches