HP HP Certifications HPE6-A29 Questions & Answers

• Question 171:

  Which actions does ARM (Adaptive Radio Management) perform? (Choose two)

  A. allows controllers to provision the AP Radio type

  B. allows controllers to provision the best channel for APs

  C. allows controllers to provision the best power setting for APs

  D. allows controllers to provision allowed Radio bands

  E. allows controllers to provision lower power when unauthorized APs are detected

  Correct Answer: BC

• Question 172:

  One hundred (100) additional APs were deployed in an existing network. But some APs are not able to connect to the lms-ip address, even though all of the APs belong to the same AP group. Which of the following are NOT potential causes? (Choose two).

  A. The problem APs are not getting an IP address.

  B. The problem APs have the wrong lms-ip address setting.

  C. There is a firewall between the problem APs and the controller blocking PAPI.

  D. The controller does not support that many APs in a single AP-Group.

  E. There are not enough AP licenses to support the additional quantity of APs.

  Correct Answer: BD

• Question 173:

  Which of these are NOT a client attribute that can be configured in user derivation rules?

  A. MAC address

  B. DHCP option value

  C. BSSID

  D. Filter ID

  E. encryption

  Correct Answer: D

• Question 174:

  A client device associates with an SSID provisioned with 802.1X authentication. The client is set for PEAP authentication. EAP termination (AAA Fastconnect) is disabled on the controller. But the client continuously cycles through the authentication process. Which of the following could cause this? (Choose two)

  A. The client is provisioned with the wrong EAP type.

  B. The client has an expired or revoked server certificate.

  C. The DHCP server is not enabled.

  D. The VLAN is missing for the SSID.

  E. The controller does not support PEAP in this mode.

  Correct Answer: AB

• Question 175:

  What is the purpose of Mesh Clusters?

  A. To separate Mesh points from Mesh Portals.

  B. To ensure that mesh APs with the same VAPs are not in the same cluster.

  C. To define a group of mesh APs that create mesh links with each other.

  D. To cluster mesh APs of the same model together.

  E. To enable mesh APs to join the nearest mesh portal cluster.

  Correct Answer: C

• Question 176:

  The permanent licenses on the controller will be deleted with the use of which command?

  A. delete license

  B. write erase

  C. Licenses cannot be deleted once activated

  D. write erase all

  E. reboot delete all

  Correct Answer: D

• Question 177:

  Which of the following functions can be configured in the Controller WIP wizard? (Choose three.)

  A. Configure APs as Air Monitors

  B. Configure rules for AP classification.

  C. Configure preset levels for intrusion detection

  D. Blacklisting Rules for clients

  E. Identify encryption method used in your network.

  Correct Answer: BCE

• Question 178:

  Aruba Client Match does NOT use which of the following parameters to determine the best AP for a client connection?

  A. Device type

  B. Location

  C. Signal to Noise Ratio

  D. Access Point load

  E. Spectrum Analysis

  Correct Answer: E

• Question 179:

  Which of the following is an Aruba Layer 3 redundancy mechanism?(Choose two) A.HA

  B. Backup LMS-IP

  C. VRRP

  D. Backup AP group

  E. ARM

  Correct Answer: AB

• Question 180:

  Exhibit: Referring to the diagram provided for this question, representing an office wireless LAN deployment, there will be approximately 250 users in the offices section of the building. All Switches are setup as L3 routers.

  

  According to Aruba best practice, which network device is the best choice for the wireless clients' default gateway?

  A. device 'A'

  B. device 'B'

  C. device 'C'

  D. device 'D'

  E. device 'C or D'

  Correct Answer: B