HP HP2-T26 Online Practice Questions and Exam Preparation

HP HP2-T26 Online Questions & Answers

• Question 171:

  Which utility should you use to gather detailed information about SNMP traffic on a Windows server?

  A. Microsoft Performance Monitor
  B. Microsoft Network Monitor
  C. Microsoft SNMP Monitor
  D. Microsoft System Event Viewer
  B. Microsoft Network Monitor

• Question 172:

  How do you access the EBSU?

  A. Press F9 during POST.
  B. Press F11 during POST.
  C. Boot from Smart Setup Media.
  D. Boot from Smart Start Media.
  C. Boot from Smart Setup Media.

• Question 173:

  Which capability does the Unified Extensible Firmware Interface (UEFI) provide in ProLiant Blade servers?

  A. advanced diagnostics for fault isolation
  B. PXE boot device selection
  C. shortcut keys under OS control
  D. function key selection during startup
  B. PXE boot device selection

• Question 174:

  Refer to the exhibit below.

  

  A customer reports that Insight Display shows five NICs installed in a half-height server blade, but a connection to only two of them can be established. What could cause this to happen?

  A. The NICs and interconnect modules are running different firmware revisions.
  B. The NICs and iLO share the same interface.
  C. Some interconnect modules are powered off.
  D. The NICs are multifunction cards and also operate in iSCSI mode.
  D. The NICs are multifunction cards and also operate in iSCSI mode.

• Question 175:

  What should you do to determine the list of hotfixes installed on a Windows server?

  A. Run regedit and look under HKLM\Software\Microsoft\Windows\CurrentVersion\HotFix.
  B. Open the Windows Update applet in the control panel.
  C. Use the systeminfo command.
  D. Right-click on My Computer and select the Advanced tab.
  C. Use the systeminfo command.

• Question 176:

  A customer is experiencing intermittent storage connectivity issues in their BladeSystem environment. After collecting the log files from the external storage system and the interconnects, you determine the problem is in the Onboard Administrator configuration.

  Which step should you take next in the troubleshooting process?

  A. Implement preventive measures.
  B. Initiate the replacement procedure of the midplane.
  C. Plan the repair procedure.
  D. Verify if the solution is covered by a carepack.
  C. Plan the repair procedure.

• Question 177:

  Which HP mezzanine option supports hardware RAID for Solid State Drives (SSDs)?

  A. HP PCI Express Mezzanine Pass-Thru card
  B. HP StorageWorks IO Accelerator
  C. HP Smart Array P712m Controller
  D. HP Smart Array P700m Controller
  C. HP Smart Array P712m Controller

• Question 178:

  After a BL460c G7 system board replacement due to a mismatched processor support error, the engineer performs a firmware verification and update process. As a preventive measure, which firmware must be checked and updated, if required?

  A. the primary firmware on the system board
  B. both the primary and backup system firmware on the system board
  C. only the iLO firmware to the current release, if required
  D. only the baseboard management controller firmware, if required
  A. the primary firmware on the system board

• Question 179:

  Which CSR category allows a customer to habe HP replace a failed part under warranty at no additional charge?

  A. CSR optional
  B. CSR Advance Unit Replacement
  C. CSR express
  D. CSR mandatory
  D. CSR mandatory

• Question 180:

  What provides information on the software inventory of a server and available updates?

  A. HP Subscribers Choice
  B. HP System Management Homepage (SMH)
  C. Version Control Agent (VCA)
  D. Version Control Repository Manager (VCRM)
  C. Version Control Agent (VCA)