Extreme Networks EW0-300 Online Practice Questions and Exam Preparation

Extreme Networks EW0-300 Online Questions & Answers

• Question 131:

  When the CLI command show vlan corporate, is issued, the Protocol field has a value of NONE? Why is this so?

  A. There is a system error, there is no such thing as a NONE in the protocol field
  B. A protocol filter has not yet been configured for the vlan corporate
  C. A protocol filter was added to this VLAN. That protocol filter was later deleted fromthe switch.
  D. None of these.
  C. A protocol filter was added to this VLAN. That protocol filter was later deleted fromthe switch.

• Question 132:

  Type-2 LSAs are genereated by this OSPF router type

  A. ASBR
  B. ABR
  C. DR
  D. ODR
  C. DR

• Question 133:

  The default OSPF router dead interval for Extreme Networks switches is

  A. 10 seconds
  B. 40 seconds
  C. 120 seconds
  D. 180 seconds
  B. 40 seconds

• Question 134:

  Radius and Tacacs+ are both access security features supported by Extreme Networks. Servers running these two features are also known as AAA servers. Where do these 3 A's stand for?

  A. authentication, authorization, accounting
  B. authentication, access, accounting
  C. attribute, authorization, accounting
  D. authentication, arrival, accounting
  A. authentication, authorization, accounting

• Question 135:

  On an Extreme Networks switch, how many bits comprise an OSPF area ID?

  A. 32 BITS
  B. 48 BITS
  C. 64 BITS
  D. 128 BITS
  A. 32 BITS

• Question 136:

  The majority of Extreme Networks switches have a dedicated out of band management port and VLAN.

  The 10/100BASE-TX Ethernet management port allows you to communicate directly to the CPU of the switch. If you want the switch to forward traffic from the mgmt VLAN to other VLANS you just have to enable ipforwarding on all VLANS including the management VLAN.

  A. TRUE
  B. FALSE
  B. FALSE

• Question 137:

  An LSP is a link state packet used by which routing protocol?

  A. OSPF
  B. RIP
  C. BGP
  D. None of these
  D. None of these

• Question 138:

  Which of the following statements fit the description of PIM sparse mode? (choose three that apply)

  A. PIM sparse mode is suitable for network with minimal multicast deployment.
  B. PIM sparse mode builds shared trees based on a common Rendez-Vous Point
  C. In PIM sparse mode the RPF check depends on the tree type
  D. An explicit join is not required in PIM sparse mode.
  A. PIM sparse mode is suitable for network with minimal multicast deployment.
  B. PIM sparse mode builds shared trees based on a common Rendez-Vous Point
  C. In PIM sparse mode the RPF check depends on the tree type
  D. An explicit join is not required in PIM sparse mode.

• Question 139:

  An Alpine 3808 switch can operate without the SMMi management module?

  A. TRUE
  B. FALSE
  B. FALSE

• Question 140:

  Which of the following IP destination addresses can be used for multicast streams?

  A. 10.1.0.0
  B. 226.0.0.1
  C. 192.168.10.0
  D. 172.18.255.255
  B. 226.0.0.1