Extreme Networks EW0-300 Online Practice Questions and Exam Preparation

Extreme Networks EW0-300 Online Questions & Answers

• Question 11:

  The pre-empt option in VRRP is enabled by default on Extreme Networks switches. Pre-empt ensures that

  A. The number of ports on the VLAN does not count in the election process
  B. A message is sent to all hosts requiring them to flush their ARP table.
  C. No back-to-back link is required between master and backup.
  D. There is an immediate fallback to the original master when the problem is resolved.
  D. There is an immediate fallback to the original master when the problem is resolved.

• Question 12:

  By default, the OSPF routerID for an Extreme switch is selected automatically, and uses the lowest IP address of the router interefaces.

  A. TRUE
  B. FALSE
  B. FALSE

• Question 13:

  In Extreme Ware what is the normal ACL behavior for incoming traffic when there is no default rule configured?

  A. Explicit permit
  B. Explicit deny
  C. Implicit permit
  D. Implicit deny
  C. Implicit permit

• Question 14:

  

  According to accompanying diagram and ACL configuration it is possible to telnet from host A to any of the switch IP addresses.

  A. True
  B. False
  B. False

• Question 15:

  Which CLI command would you use to configure vlan tracking towards vlan engineering for an ESRP protected VLAN manufacturing?

  A. config vlan manufacturing add track-vlan engineering
  B. config esrp add track-vlan engineering
  C. enable vlan manufacturing add track-vlan engineering
  D. enable esrp add track-vlan engineering
  A. config vlan manufacturing add track-vlan engineering

• Question 16:

  SSH2 on Extreme Networks ? chipset switches enables encrypted telnet sessions towards the witch.

  SSH2 Client and Server both have a private key and exchange a public key before the connection is set-up.

  A. TRUE
  B. FALSE
  A. TRUE

• Question 17:

  The normal behavior of a Router is to forward Unicast packets and block broadcast traffic.

  A. True
  B. False
  A. True

• Question 18:

  The following ExtremeWare components are required on Extreme Networks switches with the ? chipset to build an SLB system. (Choose all three that apply)

  A. Nodes
  B. Pools
  C. Virtual Servers
  D. Load balance cache engines
  A. Nodes
  B. Pools
  C. Virtual Servers

• Question 19:

  Is it possible to configure a single physical port into different STPD's?

  A. No, this is never possible.
  B. This is possible when this port is not in 802.1D mode for any of the STPDs.
  C. This is only possible when this port is in 802.1D mode for all of the STPDs.
  D. This is possible when this port is not in 802.1D mode for more than one STPD.
  D. This is possible when this port is not in 802.1D mode for more than one STPD.

• Question 20:

  Extreme Networks IS? Chipset switches allows you to run simultaneously the Radius and Tacacs +features.

  A. True
  B. False
  B. False