Extreme Networks EW0-100 Online Practice Questions and Exam Preparation

Extreme Networks EW0-100 Online Questions & Answers

• Question 201:

  Given router interfaces 10.0.0.1/24, 10.10.10.10/24, 192.168.0.1/24, and 192.168.255.254/24 on a Summit7i switch what will be the OSPF router ID given the following command: config ospf routerid automatic?

  A. 10.0.0.1/24
  B. 10.10.10.10/24
  C. 192.168.0.1/24
  D. 192.168.255.254/24
  D. 192.168.255.254/24

• Question 202:

  The IP protocol filter has mistakenly been deleted from your switch. Which commands will you use to restore it to the switch?

  A. create protocol ip etype 0800
  B. create protocol ip etype 0802
  C. create protocol ip etype 0804
  D. create protocol ip etype 0806
  A. create protocol ip etype 0800
  D. create protocol ip etype 0806

• Question 203:

  Which of the following are ways the IP route table becomes populated?

  A. default routes
  B. IGMP snooping
  C. relative route priorities D. None of these.
  A. default routes

• Question 204:

  The __________ STPD s0 command is used to reset all STP values to default settings for that STPD.

  unconfig

• Question 205:

  Which ExtremeWare feature permits ESRP to increase the number of protected VLANs by placing them under the control of a master VLAN?

  A. ESRP groups
  B. ESRP domains
  C. ESRP host attach
  D. None of these.
  B. ESRP domains

• Question 206:

  QoS policy is applied _____ in an Extreme switch.

  A. per port
  B. per queue, per port
  C. per queue
  D. None of these.
  B. per queue, per port

• Question 207:

  How could you disable MAC address learning for ports 1-8 on a Summit5i switch?

  A. Enter the command disable ports learning 1-8.
  B. Enter the command disable mac-learning ports 1-8.
  C. Enter the command disable ports mac-learning 1-8.
  D. Enter the command disable learning ports 1-8.
  D. Enter the command disable learning ports 1-8.

• Question 208:

  Two Extreme Networks switches are connected at Layer-2 via a third-party Ethernet switch. What will EDP report on the ports connecting to the third-party switch?

  A. Nothing. EDP is only supported between Extreme Networks devices.
  B. The switch type and vendor of the third party switch (third party VLAN information isnot supported).
  C. The two Extreme switches will appear to be directly connected.
  D. None of these.
  C. The two Extreme switches will appear to be directly connected.

• Question 209:

  Which command would you use to create a default route with a metric of 5 and a gateway of 10.0.0.1?

  A. config iproute add default 10.0.0.1 5
  B. config iproute add default 5 10.0.0.1
  C. config iproute add default 10.0.0.1 5
  D. config iproute add default 5 10.0.0.1
  A. config iproute add default 10.0.0.1 5

• Question 210:

  What is the standard for signaling QoS values in a tagged Ethernet frame?

  802.1p