Extreme Networks EW0-100 Online Practice Questions and Exam Preparation

Extreme Networks EW0-100 Online Questions & Answers

• Question 191:

  How many bits are in an OSPF area ID?

  A. 32 bits
  B. 48 bits
  C. 64 bits
  D. 128 bits
  A. 32 bits

• Question 192:

  If a switch within a spanning tree domain has its spanning tree protocol disabled:

  A. BPDUs from other switches in the spanning tree domain will be blocked.
  B. BPDUs from adjacent switches running spanning tree will pass through the switch.
  C. The switch will use topology change BPDUs to inform the other switches to alter theexisting active topology.
  D. None of these
  B. BPDUs from adjacent switches running spanning tree will pass through the switch.

• Question 193:

  Exhibit:

  

  What is the last key that must be pressed to boot using the secondary image and configuration?

  A. 2
  B. 4
  C. f
  D. p
  C. f

• Question 194:

  You are taking steps to secure SNMP access to your switches after reviewing CERT Advisory CA-2002-03 on the Extreme Networks web site. Your supervisor instructs you to configure 192.168.0.254 as the only SNMP trap receiver with read-write access. How will you do this?

  A. Enter the command config snmp 192.168.0.254 trapreceiver add community private.
  B. Enter the command config snmp add 192.168.0.254 trapreceiver community private.
  C. Enter the command config snmp trapreceiver 192.168.0.254 add community private.
  D. Enter the command config snmp add trapreceiver192.168.0.254 community private.
  D. Enter the command config snmp add trapreceiver192.168.0.254 community private.

• Question 195:

  Which of the following is a predefined protocol filter?

  A. RIP
  B. IPX_SNAP
  C. SNMP
  D. None of these.
  B. IPX_SNAP

• Question 196:

  Exhibit:

  

  You have been assigned the task of configuring an 8-port load share group between two switches that uses the address-based algorithm. Which of the following commands will provide you with the desired result?

  A. Summit #1: enable sharing 1 grouping 1-8 algorithm address-based, Summit #2:enable sharing 8 grouping 1-8 algorithm address-based
  B. Summit #1: enable sharing 1 grouping 1-8 algorithm address-based, Summit #2:enable sharing 1 grouping 1-8 algorithm address-based
  C. Summit #1: enable sharing 1 grouping 1-8 address-based algorithm, Summit #2:enable sharing 1 grouping 1-8 address-based algorithm
  D. Summit #1: enable sharing 1 grouping 1-8 address-based algorithm, Summit #2:enable sharing 8 grouping 1-8 address-based algorithm
  B. Summit #1: enable sharing 1 grouping 1-8 algorithm address-based, Summit #2:enable sharing 1 grouping 1-8 algorithm address-based

• Question 197:

  Exhibit:

  

  Which command would have caused the following errors?

  A. config ports 9-12 auto off duplex full speed 1000
  B. disable ports 9-12 auto
  C. config ports 9:12 auto off duplex full speed 1000
  D. disable ports 9:12 auto
  A. config ports 9-12 auto off duplex full speed 1000

• Question 198:

  How would you stop a configuration download from happening?

  A. cancel configuration download
  B. download configuration cancel
  C. configuration download cancel
  D. delete configuration download
  B. download configuration cancel

• Question 199:

  Before ExtremeWare will route packets between VLANs, the following must be configured:

  A. A valid IP address in each appropriate VLAN.
  B. IP forwarding must be enabled on each VLAN.
  C. Ports must be added to participating VLANs.
  D. All of these.
  D. All of these.

• Question 200:

  Which of the following are valid ESRP master election algorithms?

  A. ports_track_priority_mac
  B. ports_priority_track_mac
  C. track_ports_priority_mac
  D. track_priority_ports_mac
  A. ports_track_priority_mac
  C. track_ports_priority_mac