Extreme Networks EW0-100 Online Practice Questions and Exam Preparation

Extreme Networks EW0-100 Online Questions & Answers

• Question 151:

  Which of the following is a predefined protocol filter?

  A. ICMP
  B. IPX
  C. ARP
  D. None of these.
  B. IPX

• Question 152:

  The default parameters for QP8 are:

  A. Minimum bandwidth 0%, maximum bandwidth 100%, and low priority.
  B. Minimum bandwidth 50%, maximum bandwidth 50%, and low priority.
  C. Minimum bandwidth 100%, maximum bandwidth 0%, and low priority.
  D. None of these.
  A. Minimum bandwidth 0%, maximum bandwidth 100%, and low priority.

• Question 153:

  When a port is added to a tagged VLAN, jumbo frame support must be enabled to compensate for the increased frame size.

  A. True
  B. False
  B. False

• Question 154:

  

  Which predefined protocol filter does the following information relate to?

  ip

• Question 155:

  Unlike VRRP, the Extreme Standby Router Protocol provides redundancy at both the data link and network layers.

  A. True
  B. False
  A. True

• Question 156:

  In spanning tree, the designated bridge is the switch with the ___________.

  A. least-cost path to the root bridge
  B. highest bridge priority
  C. lowest port cost on all ports
  D. None of these
  A. least-cost path to the root bridge

• Question 157:

  Which of the following are ways the IP route table becomes populated?

  A. IP multinetting
  B. BGP
  C. VLAN aggregation
  D. None of these.
  B. BGP

• Question 158:

  OSPF area 10.10.10.10 is a stub area that connects to OSPF area 1.1.1.1. OSPF area 1.1.1.1 connects to the backbone area 0.0.0.0. The ABR connecting areas 10.10.10.10 and 1.1.1.1 no longer shows any routes to other areas after being rebooted following an ExtremeWare code upgrade. What is the issue and how should it be resolved?

  A. An ABR's OSPF router ID changed.
  B. Virtual links should be reconfigured.
  C. A new OSPF area was configured.
  D. OSPF should be disabled and then re-enabled.
  A. An ABR's OSPF router ID changed.
  B. Virtual links should be reconfigured.

• Question 159:

  There are three routers in OSPF area 56.0.0.1. You find that two of the routers become the DR and BDR. However, when the DR fails, the BDR becomes the DR, but the ODR does not become the new BDR. Why is this happening?

  A. The router priority is set to 0.
  B. The router priority is set to 255.
  C. The router is an ASBR.
  D. None of these.
  A. The router priority is set to 0.

• Question 160:

  Up to this number of VLANs can be tagged on a single link between Extreme Networks switches.

  3000