Extreme Networks EW0-100 Online Practice Questions and Exam Preparation

Extreme Networks EW0-100 Online Questions & Answers

• Question 141:

  Certain entries are still in the log after you attempted to clear it. You realize this happened because you forgot to use the __________ keyword with the CLEAR LOG command.

  static

• Question 142:

  Which command should be used to configure the link cost for RIP?

  A. config rip link-cost
  B. config rip link-metric
  C. config rip metric-table
  D. None of these.
  D. None of these.

• Question 143:

  Which of these are valid load sharing algorithms?

  A. Ratio-based
  B. Address based
  C. MAC-based
  D. All of these.
  B. Address based

• Question 144:

  A VLAN can be a member of up to 64 STPDs.

  A. True
  B. False
  B. False

• Question 145:

  What information can you find using the show edp command?

  A. VLANs configured on the remote switch.
  B. The ports that are disabled on the remote switch.
  C. The master port of any load share groups.
  D. The speed and duplex settings of the ports connecting the two switches.
  A. VLANs configured on the remote switch.

• Question 146:

  Which command would you use to configure the switch to disregard STP for selected VLANs?

  A. enable ignore-stp vlan
  B. enable ignore-bpdu vlan
  C. enable ignore-bpdu stpd
  D. enable ignore-stp vlan
  D. enable ignore-stp vlan

• Question 147:

  You would use the __________ command to turn off ECMP. Do not abbreviate the CLI command.

  disable iproute sharing

• Question 148:

  The __________ field indicates whether IP forwarding is enabled globally when the show ipconfig command is entered.

  IP routing

• Question 149:

  How do you remove the IP address that has been assigned to the default VLAN?

  A. config default unconfig ipaddress
  B. config default delete ipaddress
  C. unconfig default ipaddress
  D. disable default ipaddress
  C. unconfig default ipaddress

• Question 150:

  You have used the command config syslog add 192.168.1.1 local0 info to set up your syslog server. You later check the log and see that no messages have been recorded. What command should you have entered next? Do not abbreviate the CLI command.

  enable syslog