EMC D-PSC-MN-01 Online Practice Questions and Exam Preparation

EMC D-PSC-MN-01 Online Questions & Answers

• Question 31:

  DRAG DROP

  A platform engineer is creating a Dell PowerScale cluster using the Configuration Wizard. They have selectedthe Create a new cluster option.What Is the correct sequence of steps to create the cluster?

  Select and Place:

  

  

• Question 32:

  A platform engineer is at a customer site to replace a failed Dell EMC PowerScale Gen 6 node. After removing the compute module, they observe lit LEDs inside the removed node. What is the recommended response?

  A. This is not normal; they need to shut down the partner node.
  B. There is an internal electrical fault; they should call support.
  C. The node is not yet completely shut down; they should wait.
  D. This is normal; they should continue with the procedure.
  D. This is normal; they should continue with the procedure.

• Question 33:

  What type of NIC can be used for the external network on a Dell PowerScale F600 node?

  A. 1/10 GbE
  B. 10/100 GbE
  C. 10/25 GbE
  D. 25/40 GbE
  C. 10/25 GbE

• Question 34:

  A customer is planning to expand a Dell PowerScale Gen5 cluster with H500 nodes What is a consideration?

  A. A minimum of three H500 chassis are needed.
  B. All new nodes must be on the network.
  C. A minimum of four H500 nodes are needed.
  D. A minimum of one H500 chassis is needed.
  D. A minimum of one H500 chassis is needed.

• Question 35:

  After finishing the installation of a Dell EMC PowerScale Gen 6 cluster, a customer asks the platform engineer to demonstrate the proper way to remove and replace the front node bezel. They remove the bezel successfully. What is the correct way to replace the bezel?

  A. Make sure all the front-loaded hard drives have no red LEDs, then replace the bezel and secure it with the thumb screws.
  B. Center the bezel faceplate on the node chassis and press the left side, then the right side, until the bezel clicks.
  C. Push on the bezel ends and press the bezel until it latches.
  D. Align the bezel ends with the clips and press the bezel center.
  D. Align the bezel ends with the clips and press the bezel center.

• Question 36:

  What is the rack size of an F600 node?

  A. 3U
  B. 2U
  C. 1U
  D. 4U
  C. 1U

• Question 37:

  What security mechanism is used in the OneFS API to encrypt communications?

  A. SED
  B. RBAC
  C. HTTPS
  D. OpenSSH
  C. HTTPS

• Question 38:

  What should the platform engineer do to retain critical information when replacing a system board on a Dell EMC PowerScale F200 node?

  A. Run isi_node_restore -force
  B. Flash the BIOS
  C. Reinstall the PowerScale license
  D. Run EasyRestore
  D. Run EasyRestore

• Question 39:

  A platform engineer must install several Dell PowerScale clusters. Which rack should they use for the A3000 nodes?

  A. Titan-HD
  B. Titan-D
  C. Titan-P
  A. Titan-HD

• Question 40:

  What step should be performed when testing connectivity between a Dell EMC PowerScale cluster and an NFS client?

  A. Map a drive to the default IFS share on the cluster
  B. Ping the DNS server used by the cluster from PuTTY
  C. Create an NFS export and mount it on the NFS client
  D. In a Web browser, type the cluster name and press Enter
  C. Create an NFS export and mount it on the NFS client