EMC D-PSC-MN-01 Online Practice Questions and Exam Preparation

EMC D-PSC-MN-01 Online Questions & Answers

• Question 21:

  What is a precaution when working with Dell EMC PowerScale equipment?

  A. Nodes can operate above 40 degrees C, but only for limited periods of time.
  B. Connections to the branch circuit need not be properly grounded.
  C. Use side stabilizers if the rack is not securely bolted to the floor.
  D. The total rack load should not exceed 70% of the branch circuit rating.
  C. Use side stabilizers if the rack is not securely bolted to the floor.

• Question 22:

  A customer notices a platform engineer intentionally leaving a 1U gap underneath a Dell PowerScale H400 chassis during racking and stacking What is the purpose of the gap?

  A. Backend Ethernet switch
  B. Cable management tray
  C. Location to install archive nodes
  D. Required blanking panel for node separation
  B. Cable management tray

• Question 23:

  A platform engineer is building a new Dell EMC PowerScale cluster. The configuration wizard prompts to configure int-a. What is a consideration when configuring int-a?

  A. Must be on the same subnet as int-b.
  B. Must use the same subnet as groupnet0, subnet0.
  C. Must be on a separate subnet from int-b.
  D. Must use the same subnet as node 1, ext-1.
  C. Must be on a separate subnet from int-b.

• Question 24:

  What does a blue handle indicate on Dell EMC PowerScale Gen 6 hardware?

  A. Node should be shut down for maintenance procedures
  B. Hardware does not require ESD procedure
  C. Node can remain online during maintenance procedures
  D. Hardware does not require SolVe Desktop activity
  C. Node can remain online during maintenance procedures

• Question 25:

  A customer wants to add SSDs to the drive sleds in a Dell PowerScale H600 node for higher storage performance. What should the platform engineer tell the customer?

  A. Cache expansion requires a Dell Professional Services engagement.
  B. Hybrid node SSDs in identical sled locations can be used for either cache or primary storage.
  C. Only F series nodes can use SSDs for primary storage.
  D. Each sled must have an equal number of SSDs.
  B. Hybrid node SSDs in identical sled locations can be used for either cache or primary storage.

• Question 26:

  Which are configured during the Configuration Wizard process?

  A. Contact information Secure Remote Services
  B. SmartConnect LDAP
  C. Date and time Secure Remote Services
  D. Date and time Encoding setting
  C. Date and time Secure Remote Services

• Question 27:

  A platform engineer is creating a new Dell EMC PowerScale cluster that must meet SEC 17a-4f rules. Node 1 is powered on and cabled. What action is needed to meet the requirement?

  A. Activate the Enterprise mode license
  B. Create a new cluster
  C. Reboot into SmartLock Compliance mode
  D. Configure the network
  C. Reboot into SmartLock Compliance mode

• Question 28:

  Which resource should be consulted before performing any Dell PowerScale platform maintenance activities?

  A. Dell SolVe Online
  B. Dell Technical Support
  C. Dell iDRAC Service Module
  D. OneFS logs and error messages
  A. Dell SolVe Online

• Question 29:

  A platform engineer needs to study the solution diagrams and topologies. What should the engineer consult?

  A. PEQ
  B. Site Preparation and Planning Guide
  C. Dell EMC support
  D. SolVe Online
  D. SolVe Online

• Question 30:

  Which interface is capable of providing the most extensive set of information about the cluster state and configuration settings?

  A. Web console
  B. Serial console
  C. CLI
  D. Platform API
  D. Platform API