Acme Packet AP0-001 Online Practice Questions and Exam Preparation

Acme Packet AP0-001 Online Questions & Answers

• Question 111:

  Of the following configured local policy preferences that the Net-Net 4000 sorts through, which one of the four preference discriminators listed below would be ranked the second highest priority?

  A. codec
  B. lowest cost
  C. next hop
  D. realm
  A. codec

• Question 112:

  __________ is the percentage of a Net-Net 4000 peer advertisement time for the other peer in the high availability (HA) cluster to wait before considering the peer out of service.

  A. 200%
  B. percent-drift
  C. 310%
  D. standard-deviation-score
  B. percent-drift

• Question 113:

  The boot parameters, passwords and licensing information are stored in __________.

  A. SDRAM
  B. NVRAM
  C. Flash
  D. CAM
  B. NVRAM

• Question 114:

  When configuring a network interface on the Net-Net 4000, the __________ feature allows you to set parameters for gateway failure detection.

  A. utility address
  B. redundancy next hop
  C. gateway failure message
  D. gateway heartbeat
  D. gateway heartbeat

• Question 115:

  You configure the _____________and _____________elements to use the Net-Net 4000 to perform load balancing between two downstream SIP proxies.

  A. realm steering pool
  B. local policy session agent group
  C. session router session router group
  D. proxy proxy pool
  B. local policy session agent group

• Question 116:

  The __________ field value in the network interface configuration is used as the source IP address for ARP requests from the secondary Net-Net 4000 in a highly available pair when in the standby role.

  A. sec-utility-address
  B. pri-utility-addr
  C. ip-address
  D. arp-address
  A. sec-utility-address

• Question 117:

  When SIP sessions are terminated and re-originated as they flow through the Net-Net 4000, the ____________ is rewritten to force all session related media to be routed through Net-Net 4000.

  A. Via
  B. From
  C. SDP
  D. Contact
  C. SDP

• Question 118:

  To replace the Net-Net 4000 running configuration with a previous configuration, perform the following:

  A. Use the exec last-known good config command
  B. Use the rollback command
  C. Use the restore-backup-config command
  D. None of the above
  C. Use the restore-backup-config command

• Question 119:

  Which three of the following are NAPT mappings that are pulled by the Standby node during media state checkpointing in high availability (HA) architectures?

  A. Source port
  B. Protocol ID
  C. Route
  D. Ingress Interface
  A. Source port
  B. Protocol ID
  C. Route

• Question 120:

  The __________ field allows you to set the health score at which a Net-Net 4000, if it the standby peer in a high availability (HA) scenario, will switchover to the active state without waiting for any configured timers to expire.

  A. emergency-threshold
  B. health-threshold
  C. active-threshold
  D. switchover-threshold
  A. emergency-threshold