Acme Packet AP0-001 Online Practice Questions and Exam Preparation

Acme Packet AP0-001 Online Questions & Answers

• Question 101:

  The __________ parameter allows for multiple network interfaces to be bound to a single physical interface.

  A. sub-port-id
  B. vlan-id
  C. hip-ip-addr
  D. vlan
  A. sub-port-id

• Question 102:

  Using the command show redundancy sipd, redundancy statistics and transactions are displayed. Which 3 of the following statistics provide information about the state of SIP signaling checkpointing?

  A. CPU Utilization
  B. Error responses
  C. Retransmissions sent
  D. Duplicate requests
  B. Error responses
  C. Retransmissions sent
  D. Duplicate requests

• Question 103:

  __________ is the percentage of a Net-Net 4000 peer advertisement time for the other peer in the high availability (HA) cluster to wait before considering the peer out of service.

  A. 200%
  B. percent-drift
  C. 310%
  D. standard-deviation-score
  B. percent-drift

• Question 104:

  In high availability (HA) architectures, changes to the state of the Active Net-Net 4000 are queued in journals. Requests from the Standby node results in information about these changes being pulled by Standby from the Active node. The three checkpointed states are __________, __________ and __________.

  A. configuration state
  B. alarm state
  C. media state
  D. signaling state
  A. configuration state
  C. media state
  D. signaling state

• Question 105:

  In high availability (HA) architectures, changes to the state of the Active Net-Net 4000 are queued in journals. Requests from the Standby node results in information about these changes being pulled by Standby from the Active node. The three checkpointed states are __________, __________ and __________.

  A. configuration state
  B. alarm state
  C. media state
  D. signaling state
  A. configuration state
  C. media state
  D. signaling state

• Question 106:

  The boot parameters, passwords and licensing information are stored in __________.

  A. SDRAM
  B. NVRAM
  C. Flash
  D. CAM
  B. NVRAM

• Question 107:

  Of the following configured local policy preferences that the Net-Net 4000 sorts through, which one of the four preference discriminators listed below would be ranked the second highest priority?

  A. codec
  B. lowest cost
  C. next hop
  D. realm
  A. codec

• Question 108:

  The __________ field value in the network interface configuration is used as the source IP address for ARP requests from the secondary Net-Net 4000 in a highly available pair when in the standby role.

  A. sec-utility-address
  B. pri-utility-addr
  C. ip-address
  D. arp-address
  A. sec-utility-address

• Question 109:

  When configuring the Net-Net 4000 to proxy registrations in the H323 stack element, the ___________.

  A. process-registration parameter must be disabled in the H323 stack for the access network.
  B. proxy-mode parameter in the H323 stack must be set to enabled.
  C. tcp-keepalive parameter must always be disabled.
  D. Q.931 and dynamic port range must not overlap.
  D. Q.931 and dynamic port range must not overlap.

• Question 110:

  Berpd manages switchovers between the active and standby Net-Net 4000, and exchanges____________.

  A. Media flows
  B. Signaling information
  C. Health state
  D. All of the above
  C. Health state