Cisco 352-011 Online Practice Questions and Exam Preparation

Cisco 352-011 Online Questions & Answers

• Question 61:

  When is it required to leak routes into an IS-IS Level 1 area?

  A. when equal cost load balancing is required between the backbone and non-backbone areas
  B. when unequal cost load balancing is required between the backbone and non-backbone areas
  C. when MPLS L3VPN PE devices are configured in the Level 1 areas
  D. when a multicast RP is configured in the non-backbone area
  C. when MPLS L3VPN PE devices are configured in the Level 1 areas

• Question 62:

  On a large enterprise security solution, which two options are IDS or IPS modes of operation? (Choose two)

  A. Transparent mode
  B. Routed mode
  C. Inline mode
  D. Traffic discovery mode
  E. Promiscuous mode
  C. Inline mode
  E. Promiscuous mode

• Question 63:

  Which two techniques are used in an OSPF network design to slow down the distribution of topology information caused by a rapidly flapping link? (Choose two)

  A. LSA throttling
  B. SPF throttling
  C. IP event dampening
  D. Link-state incremental SPF
  E. Link-state partial SPF
  A. LSA throttling
  C. IP event dampening

• Question 64:

  Which two options are IoT use cases that require the low-latency and high reliability that 5G networks provide? (Choose two)

  A. Sports and Fitness
  B. Smart Home
  C. Automotive
  D. Smart Cities
  E. Industrial Automation
  F. Health and wellness
  C. Automotive
  E. Industrial Automation

• Question 65:

  Refer to the exhibit

  

  company xyz has 150 branch location across the U.S. Each branch is connected to two aggregation router one router in each data center The network is configured with Multiple OSPF with multiple OSPF areas and the aggregation router are ABRs A requirement is to keep an optimal path to the data centers and at the same time reduce the LSA propagation and SPF recomputation during a change in any part of the network

  Which design elements should be included on the aggregation router?

  A. OSPF NSSA
  B. distribute lists
  C. OSPF summarization
  D. OSPF totally stubby area
  C. OSPF summarization

• Question 66:

  DRAG DROP

  A service provider offers Layer 2 multipoint services to their customers. Drag the protocol on the left to the target on the right to indicate the protocols that can be uesed to signal pseudowires.

  Select and Place:

  

  

  ---

  Explanation/Reference:

• Question 67:

  You are redesigning a single-level IS-IS network with 500 routers, which have short-haul and long-haul links Most of the time the routing domain is stable, but periodically interfaces on long-haul links bounce for a short period of time , causing 10 to 20 flaps in a few minutes. The probable cause is local road construction. Although fast convergence important, the client has concerns about taxing CPU cycles on the older routing platforms. What change should you recommend that both protects the CPU of the older routers during the short periods of excessive flapping, yet does not have an impact on fast convergence for all interface failures?

  A. Modify hello timers on routers with short-haul links
  B. Implement LSP generation throttling on routers with long-haul links
  C. Modify the length of time than an LSP remains in the router database without being refreshed on all routers
  D. Implement a delay between successive IS-IS LSP packet transmissions on routers with long-haul links
  D. Implement a delay between successive IS-IS LSP packet transmissions on routers with long-haul links

• Question 68:

  DRAG DROP

  A company recently had an outage after an employee plugged a switch into the corporate network, causing a change in the root bridge selection. You have been tasked to redesign the network to avoid such outages in the future. Drag the Rapid PVST+ features (on the left) that will prevent reoccurences of this incident and drop them into their definitions on the right.

  Select and Place:

  

  

  ---

  Explanation/Reference:

• Question 69:

  As a part of a network design, you should tighten security to prevent man-in-the-middle. Which two security options ensure that authorized ARP responses take place according to know IP-to-MAC address mapping? (Choose two)

  A. DHCP snooping
  B. ARP spoofing
  C. ARP rate limiting
  D. Dynamic ARP Inspection
  E. Port security
  A. DHCP snooping
  D. Dynamic ARP Inspection

• Question 70:

  You are designing a solution to connect a primary data center to a disaster recovery site, The hosted applications will be web and email servers that are provided through a virtualized environment. Which connectivity technology should you consider for this design?

  A. L2TPV3.
  B. VPWS.
  C. Point-To-Point GRE tunnels.
  D. VPLS.
  A. L2TPV3.