Cisco 352-011 Online Practice Questions and Exam Preparation

Cisco 352-011 Online Questions & Answers

• Question 81:

  For a redesign requirement of the service provider network, summarization was implemented at multiple locations for each summary range. Now some customers of the service provider are complaining of higher latency and performance issues for a server hosted in the summarized area. Which design issues must be considered when creating the summarization?

  A. Summarization adds CPU overhead on the routers sourcing the summarized advertisement.
  B. Summarization prevents the visibility of the metric to the component subnets.
  C. Summarization causes packet loss when RPF is enabled.
  D. Summarization creates routing loops.
  B. Summarization prevents the visibility of the metric to the component subnets.

• Question 82:

  As network designer, which option is your main concern with regards to virtualizing multiple network zones into a single hardware device?

  A. Fate sharing
  B. CPU resource allocation
  C. Congestion control
  D. Security
  E. Bandwidth allocation
  A. Fate sharing

• Question 83:

  DRAG DROP

  Classify the OSPF Fast Network Convergence technique by dragging the techniques on the left and dropping them into the corresponding categories on the right.

  Select and Place:

  

  

  ---

  Explanation/Reference:

• Question 84:

  Which option describes the fundamental design differences between an IP-based network design and a SAN-based?

  A. An IP-based design has redundant connectivity in the fabric and high amounts of east- west traffic, whereas a SAN-based design uses redundancy from a dual-attached host, which uses separate fabrics and has very little east-west traffic
  B. An IP-based design has redundancy from the host and high amounts of east-west traffic, whereas a SAN-based design uses redundancy in the fabric and very little east-west traffic
  C. An IP-based design has redundant connectivity in the fabric and high amounts of east- west traffic, whereas a SAN-based design uses zoning based redundancy which uses separate fabrics and has very little east-west traffic
  D. An IP-based design has redundant connectivity in the fabric and very little east-west traffic, whereas a SAN-based design uses redundancy in the host, which uses separate fabrics and has high amounts of east-west traffic
  A. An IP-based design has redundant connectivity in the fabric and high amounts of east- west traffic, whereas a SAN-based design uses redundancy from a dual-attached host, which uses separate fabrics and has very little east-west traffic

• Question 85:

  Your client is considering acquiring a new IPv6 address block so that all Ethernet interfaces on the network receive addresses based on their burned-in hardware addresses, with support for 600 VLANs. Which action do you recommend?

  A. Acquire a new /60 IPv6 network and subnet it into /70 networks, one per VLAN
  B. Acquire a new /58 IPv6 network and subnet it into /64 networks, one per VLAN
  C. Acquire a new /60 Ipv6 network and subnet it into /68 networks, one per VLAN
  D. Acquire a new/54 IPv6 network and subnet it into /64 networks , one per VLAN
  D. Acquire a new/54 IPv6 network and subnet it into /64 networks , one per VLAN

• Question 86:

  Which option is a benefit of using N-Port Virtualization?

  A. reduces the amount of domain IDs that are used in the fabric
  B. does not need to create zoning
  C. reduces latency when using local switching on Fibre Channel ports
  D. allows trunking to the upstream switch
  E. does not need to configure the upstream switches
  A. reduces the amount of domain IDs that are used in the fabric

• Question 87:

  A very large enterprise customer is migrating from EIGRP to IS-IS .What is your main concern in regards to change in the path packets take after the migration is complete?

  A. The areas sizes.
  B. The number of prefixes
  C. The redistribution points.
  D. The bandwidth and metrics of the links.
  D. The bandwidth and metrics of the links.

• Question 88:

  Which two options are potential problems with route aggregation? (Choose two)

  A. Maintaining host IP addresses during migrations
  B. Route flapping
  C. Suboptimal routing
  D. Topology hiding
  E. Asymmetric routing
  F. Prefix hijacking
  C. Suboptimal routing
  E. Asymmetric routing

• Question 89:

  You have been asked to design a wireless network solution that will implement context- aware services on an existing network that was initially deployed for data traffic only. Which two design principles would you follow to increase the location accuracy with the least possible impact on the current setup? (Choose two.)

  A. Use directional antennas to provide better cell separation.
  B. Add access points along the perimeter of the coverage area.
  C. Install additional APs in monitor mode where the co-channel interference would otherwise be affected.
  D. Increase the AP density to create an average inter-access point distance of less than 40 ft.| 12.2meters
  E. Fine tune the access point's radio configuration to have a higher average transmission power to achieve better coverage.
  A. Use directional antennas to provide better cell separation.
  D. Increase the AP density to create an average inter-access point distance of less than 40 ft.| 12.2meters

• Question 90:

  Which two statements about AToM are true? (Choose two)

  A. It encapsulates Layer 2 frames at the egress PE
  B. When using AToM, the IP precedence filed is not copied to the MPLS packet
  C. AToM supports connecting different L2 technologies using interworking option
  D. The loopback address of the PE router must be either /24 or /32
  E. It provides support for L2VPN features on ATM interfaces
  C. AToM supports connecting different L2 technologies using interworking option
  E. It provides support for L2VPN features on ATM interfaces