Cisco 352-011 Online Practice Questions and Exam Preparation

Cisco 352-011 Online Questions & Answers

• Question 51:

  A healthcare customer requested that health statistics from their infrastructure devices are to be sent over their service provider MPLS network. Which protocol must be enabled?

  A. SNMPv3
  B. Syslog TLS
  C. syslog
  D. SNMPv2
  E. SSH
  A. SNMPv3

• Question 52:

  Refer to the exhibit.

  

  How should you redesign this network running BGP to improve availability of the routers 1A and 1B at the core site?

  A. Deploy BGP PIC
  B. Use link bundles over multiple slots
  C. Enable graceful restart
  D. Create a multichassis system with the two routers
  A. Deploy BGP PIC

• Question 53:

  Which two general SDN characteristics? (Choose two)

  A. Southbound interfaces are interfaces used between the control plane and the date plane
  B. OpenFlow is considered one of the first Northbound APIs used by SDN controllers
  C. Northbound interfaces are open interfaces used between the control plane and the data plane
  D. The separation of the control plane from the data plane
  E. OVSDB is an application database management protocol
  A. Southbound interfaces are interfaces used between the control plane and the date plane
  D. The separation of the control plane from the data plane

• Question 54:

  Which interconnectivity method offers the fastest convergence in the event of a unidirectional issue between three Layer 3 switches connected together with routed links in the same rack in a data center?

  A. Fiber Ethernet connectivity with UDLD enabled
  B. Copper Ethernet connectivity with BFD enabled
  C. Fiber Ethernet connectivity with BFD enabled
  D. Copper Ethernet connectivity with UDLD enabled
  C. Fiber Ethernet connectivity with BFD enabled

• Question 55:

  An network is designed to use OSPF to reach eBGP peers. Which condition should be avoided in the design to potentially prevent the eBGP peers do not flap continuously in case of link failure?

  A. Disable BGP synchronization.
  B. Advertise IP addresses used on eBGP peer statement via a non-backbone OSPF area.
  C. Advertise via eBGP IP addresses used on eBGP peer statements.
  D. Use an ACL to block BGP in one direction.
  C. Advertise via eBGP IP addresses used on eBGP peer statements.

• Question 56:

  Refer to the exhibit.

  

  In a link failure scenario, what is a benefit of adding APS protected link to the design solution?

  A. APS switches traffic to a backup fiber automatically and sends notifications
  B. APS detects failure and sends notifications
  C. APS detects failure on transmission infrastructure based on copper.
  D. APS applies QoS policies in case Of link failure
  A. APS switches traffic to a backup fiber automatically and sends notifications

• Question 57:

  Which option describes a design benefit of root guard?

  A. It prevents switch loops caused by unidirectional point-to-point link condition on Rapid PVST+ and MST.
  B. It prevents switch loops by detecting on one-way communications on the physical port.
  C. It allows small, unmanaged switches to be plugged into ports of access switches without the risk of switch loops.
  D. It makes the port go immediately into the forwarding state after being connected.
  E. It prevents switched traffic from traversing suboptimal paths on the network.
  F. It does not generate a spanning-tree topology change upon connecting and disconnecting a station on a port.
  E. It prevents switched traffic from traversing suboptimal paths on the network.

• Question 58:

  What two options are significant drivers for 5G in IoT networks? (Choose two)

  A. Energy Efficiency
  B. Lower Latency
  C. Mass Connectivity
  D. Programmability
  E. Higher data rates
  B. Lower Latency
  C. Mass Connectivity

• Question 59:

  DRAG DROP

  Drag the fast convergence mechanisms on the left and drop them into the objectives that they accomplish.

  Select and Place:

  

  

  ---

  

  Explanation/Reference:

• Question 60:

  When a multiprotocol routing environment is designed to have several routers redistributing among the routing domains, how can routing loops be avoided?

  A. By implementing spanning tree
  B. By activating split horizon
  C. By using the AS-path attribute
  D. By using route tags
  D. By using route tags